Network Configuration - TCL 48E4900FS Operation Manual

Network Configuration

After you connect your home network to the TV, follow
the steps below to configure the network settings of your
TV.
Your TV set supports both wired and wireless network
connection.
Network
Wired Network
Wi-Fi Network
Note: For wired network connection, you need to insert
your Ethernet cable into the Ethernet port first.
- Wired Network:
Configuration: Press OK to enter, and then press
◄/► to select Static or DHCP.
Wired Network
Configuration
MAC Address
Static: In Static mode, you should input right IP
address, Netmask, Gateway and DNS to access
network. Press ▲/▼ to select an option, press OK
to enter, and then press the numeric buttons to input
numbers or press ◄/► to select numbers.
Netwrok Configuration Static
IP 0.0.0.0
Netmask 0.0.0.0
Gateway 0.0.0.0
DNS 0.0.0.0
MENU
MENU
OK
MENU
Connections and Setup
DHCP: In DHCP mode, your TV set will get IP
address, Netmask, Gateway and DNS automatically.
Press to OK to start.
MAC Address: Press OK to see the MAC address
of your TV set. Then press MENU to return or press
EXIT to exit the menu.
- Wireless Network:
In wireless menu, press ◄/► to turn wireless
network on or off.
Wi-Fi Network On
WIFI NETWORKS
MAC Address
WIFI NETWORKS: After Wi-Fi Network is set to
On, press OK to start searching for all available
wireless networks. This may take a few seconds.
After the searching is complete, select an accessible
WIFI network to connect. For some WIFI network,
you need to input the right password to access.
Select Password and press OK, then press ►. A
virtual keyboard appears. Input the password, and
then press OK to connect.
WIFI NETWORKS
HiWiFi 1
FAST_WiFi
AU_WiFi
PUB_WiFi
Home
HelloWiFi
SmileWiFi
Disconnect
OK
MAC Address: Press OK to see the MAC address
of your TV set. Then press MENU to return or press
EXIT to exit menu.
9
MENU
Refresh View Detail
MENU