Summary of Contents for OPTRONIC FSU203
- Page 1 FSU203 Replacement for OPTRONIC OP500 CRT Monitors Unteregger Strasse 53 CH-9403 Goldach...
- Page 2 Reproduction of this document or any part thereof is forbidden. Using this manual without being authorized to do so by OPTRONIC AG for anything other than personal purposes is an infringement of copyright.
-
Page 3: Table Of Contents
FSU203 Table of Contents 1 Introduction ______________________________________________________ 4 2 Device Assembly _________________________________________________ 4 3 Concept _________________________________________________________ 4 4 Video Signals ____________________________________________________ 5 5 Video Cable ______________________________________________________ 5 6 Buttons _________________________________________________________ 6 7 On Screen Menu __________________________________________________ 6 8 Changing Configuration Settings ____________________________________ 7 8.1 Show or Hide Version Information (Show Version ON/OFF)___________________ 7... -
Page 4: Introduction
SIEMENS WF470. OPTRONIC AG delivers the FSU203 pre-configured for your appli- cation. Hence, the FSU203 simply must be built in and connected. It may be that the image shown on the flat screen is not fully satisfying. In this case, all necessary adjustments can be easily done by use of buttons on the back side of the device. -
Page 5: Video Signals
At one end, the cable is equipped with a plug to connect it to the WF470, at the other end with a socket to connect it to the FSU203. The necessary electronics is integrated into the plug and the socket of the cable. -
Page 6: Buttons
The On Screen Menu can be activated by pressing button Select. If no active video source is con- nected, the reduced menu in Illustration 7 is shown. If the FSU203 has detected a video signal, the full menu in Illustration 6 is shown. The full menu offers additional functions that are only useful if a video signal is present. -
Page 7: Changing Configuration Settings
FSU203 Entry Usage Show Version ON/OFF Show or hide window with version information Store Configuration Store the actual configuration settings Load Default Values Load default configuration settings Adjust Phase Adjust the image sampling phasing Adjust Offset X Shift image horizontally... -
Page 8: Load Default Values
FSU203 8.3 Load Default Values The standard configuration can be loaded by use of main menu entry „Load Default Values“. Normally, only minor or no adjustments should be necessary. 8.4 Adjust Phase With high probability, a flickering and unstable picture can be corrected by an adjustment of the image sampling phase. -
Page 9: Trouble Shooting
If you use it already, the cause is either a hardware defect, or the electromagnetic disturbance near the active video cable, the FSU203, or the WF470 is very high. The image flickers continuously, contours Adjust the image sampling phase. - Page 10 FSU203 List Of Modifications Date Reason Edition of FSU203.411 12.09.2012 Version 1.0 Page 10 of 10...