Table of Contents
Advertisement
Installation
Do not touch the inner pins of the jacks on the rear
panel. Electrostatic discharge may cause permanent
damage to the unit.
TV Connection
Make one of the following connections, depending on the
capabilities of your existing equipment.
Tips:
Depending on your TV and other equipment you wish
to connect, there are various ways you could connect
the DVD/CD Receiver. Use one of the connections
described below.
Please refer to the manuals of your TV, VCR, Stereo
System or other devices as necessary to make the
best connections.
Caution:
Make sure the DVD/CD Receiver is connected directly
to the TV. Select the correct AV input on your TV.
Do not connect your DVD/CD Receiver to the TV via
your VCR. The DVD image could be distorted by the
copy protection system.
SCART connection
Connect the EURO AV OUTPUT (TO TV) socket on the
DVD/CD Receiver to the corresponding jacks on the TV
using the scart cable (T).
Component Video connection
Connect the COMPONENT VIDEO OUT jacks from the
DVD/CD Receiver to the corresponding jacks on the TV
using a Y P
P
cable (C).
B
R
If your television is a high-definition or "digital ready"
television, you may take advantage of the DVD/CD
Receiver's progressive scan output for higher video
resolution.
If your TV does not accept your resolution setting,
abnormal picture appears on the screen. Please read
owner's manual for TV then set the resolution that your
TV can accept.
4
AM Loop Antenna
(supplied)
FM Wire Antenna
(supplied)
Rear of DVD/CD Receiver
Video connection
Connect the MONITOR OUT jack from the DVD/CD
Receiver to the VIDEO IN jack on the TV using the video
cable supplied (V)
Antenna Connection
Connect the supplied FM/AM antenna for listening to the
radio.
Connect the AM Loop aerial to the AM aerial
connector.
Connect the FM Wire aerial to the FM aerial connector.
Notes:
To prevent noise pickup, keep the AM Loop aerial
away from the DVD/CD Receiver and other
components.
Be sure to fully extend the FM wire aerial.
After connecting the FM Wire aerial, keep it as
horizontal as possible.
possible.
Speaker System Connection
Connect the speaker wires the speaker terminals.
To obtain the best possible surround sound, adjust the
speaker parameters (volume, distance, etc.).
Notes:
Be sure to match the speaker wires to the appropriate
terminal on the components, + to + and – to –. If the
cables are reversed, the sound will be distorted and
will lack bass.
If you use front speakers with low maximum input
rating, adjust the volume carefully to avoid excessive
output on the speakers.
Optional Equipment Connection
Connect a VCR to the AUX IN connectors.
Rear of TV
VIDEO
COMPONENT VIDEO /
SCART INPUT
INPUT
PROGRESSIVE SCAN INPUT
Y
Pb
Pr
L
C
V
T
C
S
C
O
A
M
R
P.
T
To AUX IN AUDIO
(L/R)
Rear of VCR
AUDIO (L)
AUDIO (R)
To AUDIO OUT (L/R)
Advertisement
Table of Contents
