Advertisement
Quick Links
Adult assembly required.
Small parts may present choking hazard prior to assembly.
Enclosed please find simple step-by-step instructions to help you
quickly assemble your products. Before you begin we recommend
that you following the steps below:
1. Please read the instructions thoroughly.
2. Identify all parts and hardware.
3. You will need the following tools:
Philips head screw driver
Flat head screw driver
Hammer
Do Not Use Power Drills or Drivers
To protect your parts during assembly please place them on a soft
surface.
To clean surface use only water on a damp cloth. Do not use
window cleaners or cleaning abrasives as it will scratch the surface
and could damage the protective coating.
ASSEMBLY INSTRUCTIONS
ITEM NO: B5003
s
1
Advertisement
Summary of Contents for 2K FURNITURE DESIGN B5003
- Page 1 ASSEMBLY INSTRUCTIONS ITEM NO: B5003 Adult assembly required. Small parts may present choking hazard prior to assembly. Enclosed please find simple step-by-step instructions to help you quickly assemble your products. Before you begin we recommend that you following the steps below: 1.
- Page 2 WARNING ! · FAILURE TO FOLLOW THESE WARNINGS AND THE ASSEMBLY INSTRUCTIONS COULD RESULT IN SERIOUS INJURY OR DEATH. · READ ALL INSTRUCTIONS BEFORE ASSEMBLING CRIB. KEEP INSTRUCTIONS FOR FUTURE USE. ANY MATTRESS USDED IN THIS CRIB MUST BE AT LEAST 51-5/8 INCHES BY 27-1/4 INCHES WITH A THICKNESS NOT EXCEEDING 6 INCHES.
- Page 3 CONNECTION HARDWARE b: 3/5” Allen head bolt (4 pcs) a: 2-1/8” Allen head bolt (10pcs) e: Castors (2 pcs) 17.5mm 57.5mm 15mm 55mm f: Castors (2 pcs) d:Barrel nuts (10 pcs) c: 2”Allen Warench (1pc) 13mm 10mm CRIB COMPONENTS A. STATIONARY SIDE (2PCS) B.
- Page 4 Attach the stationary side (A) to the head board (B) and (C) by using bolts(a) and barrel nuts (d). Locate the metal spring (D) with tabs. Be sure the smooth side of metal spring (D) is faced upward. Position the tabs of metal spring (D) to mount to the selected position onto the legs.
- Page 5 Attach the stationary side (A) to the head board (B) and (C) by using bolts(a) and barrel nuts (d). Insert the four casters (e&f) as shown and tighten all bolts. Inspect the crib to make sure it is assembled correctly and all bolts are tight. FLAT HEAD SCREWDRIVER WRENCH FLAT HEAD SCREWDRIVER AND...
- Page 6 CONVERT THE CRIB INTO A DAY BED THE STABILIZER BAR IS SOLD SEPARATELY. You have the option to convert crib to a day bed 1.Remove the stationary side (A) near the stabilizer bar by using Allen warench (c). 2.Install the mattress support (D) in its lowest position.