Advertisement
Operating manual
6318 N/2H3PU
Product type, manufacturing date (calendar week/year of construction)
and if required, conformity mark can be found on the nameplate on the
product.
Please provide us with the contents of the nameplate when making
enquiries about the product.
ebm-papst St.Georgen GmbH & Co. KG
Hermann-Papst-Straße 1
D - 78112 St.Georgen
Phone: +49 (0) 7724 / 81-0
Fax: +49 (0) 7724 / 81-1309
info2@de.ebmpapst.com
www.ebmpapst.com
As per: 20.03.2018
Version: 1 2
Article number: 9695480302
Original operating manual
INDEX
1 SAFETY REGULATIONS AND INFORMATION
2 INTENDED USE
3 TECHNICAL DATA
4 CONNECTION AND COMMISSIONING
5 FAULTS, POSSIBLE CAUSES AND REMEDIES
6 COMPLIANCE
page 1 of 7
2
4
4
5
6
6
Advertisement
Table of Contents
Related Manuals for ebm-papst 6318 N/2H3PU
Summary of Contents for ebm-papst 6318 N/2H3PU
- Page 1 Please provide us with the contents of the nameplate when making enquiries about the product. ebm-papst St.Georgen GmbH & Co. KG Hermann-Papst-Straße 1 D - 78112 St.Georgen Phone: +49 (0) 7724 / 81-0 Fax: +49 (0) 7724 / 81-1309 info2@de.ebmpapst.com...
- Page 2 SAFETY REGULATIONS AND INFORMATION Electrical voltage and current DANGER Read the operating manual carefully before commencing work at the Electrical voltage product. Pay attention to the following warnings to avoid risk to persons or malfunctioning. Regularly check the electrical This operating manual is an integral part of the product. equipment of the product.
- Page 3 WARNING Parts transported by the airflow The product can transport small parts in the airflow and catapult them out. Ensure that there are no loose small-parts in the intake and exhaust area. Do not stand in the danger zone of the product.
- Page 4 An in situ assessment must be conducted of the heating behavior (appropriate and inappropriate operation), the protection against contact, electrical shocks, impact of foreign objects or water and the usage at altitudes higher than 2000 meters. Contact ebm-papst if you have specific queries regarding the product. page 4 of 7...
- Page 5 CONNECTION AND COMMISSIONING Voltage control Connect mechanical parts Speed control via the supply voltage is only permitted within the stipulated CAUTION supply voltage range. Speed control via Risk of cutting/squashing when PWM of the supply voltage is not removing the product from the permitted.
- Page 6 FAULTS, POSSIBLE CAUSES AND REMEDIES COMPLIANCE Replace your product by a new one, do not repair it. The product bears the CE mark. DANGER The CE mark is affixed to adequately sized nameplates. Electrical voltage at motor Within the meaning of the EMC Guideline 2014/30/EU this document is Wait five minutes after the voltage intended as: (all poles) has been switched off...
Need help?
Do you have a question about the 6318 N/2H3PU and is the answer not in the manual?
Questions and answers