Soft Start Feature; Speed Change - Makita XAD05 Instruction Manual

NOTE: When the tool is overheated, the tool stops
automatically and the lamp starts flashing. In this
case, release the switch trigger. The lamp turns off in
1 minute(s).
NOTE: Use a dry cloth to wipe the dirt off the lens of
the lamp. Be careful not to scratch the lens of lamp, or
it may lower the illumination.
Reversing switch action
CAUTION:
Always check the direction of
rotation before operation.
CAUTION:
Use the reversing switch only after
the tool comes to a complete stop. Changing the
direction of rotation before the tool stops may dam-
age the tool.
CAUTION:
When not operating the tool,
always set the reversing switch lever to the neu-
tral position.
This tool has a reversing switch to change the direction
of rotation. Depress the reversing switch lever from the
A side for clockwise rotation or from the B side for coun-
terclockwise rotation.
When the reversing switch lever is in the neutral posi-
tion, the switch lever cannot be pulled.
A
1
► 1. Reversing switch lever

Speed change

NOTICE:
Use the speed change knob only after
the tool comes to a complete stop. Changing the
tool speed before the tool stops may damage the tool.
NOTICE:
Always set the speed change knob
carefully into the correct position. If you operate
the tool with the speed change knob positioned half-
way between the position 1 and the position 2, the
tool may be damaged.
If the rotation speed significantly
NOTICE:
decreases during operation in the high speed
mode, stop the tool and change the mode to the
low speed mode. Otherwise, the motor may get
overloaded and cause a malfunction or fire.
Two speed ranges can be preselected with the speed
change knob.
To change the speed, turn the speed change knob so
that the pointer points to the position 1 for low speed
mode or the position 2 for high speed mode.
► 1. Pointer 2. Speed change knob
Electronic function
Electric brake
This tool is equipped with an electric brake. If the tool
consistently fails to quickly cease to function after the
switch trigger is released, have the tool serviced at a
Makita service center.

Soft start feature

This function allows the smooth start-up of the tool by
limiting the start-up torque.
ASSEMBLY
B
CAUTION:
switched off and the battery cartridge is removed
before carrying out any work on the tool.
Installing key holder
(Country specific)
CAUTION:
is installed securely before operation.
Screw the key holder on the tool securely. Then place
the chuck key in position.
► 1. Key holder 2. Screw 3. Chuck key
7 ENGLISH
Always be sure that the tool is
Always be sure that the key holder
1
1
2
2
3