13a electric pressure washer, 2100 psi max pressure at initial discharge per csa internal pressure testing, 1.8 gpm max flow with nozzle open at minimum pressure
® ® ® risk of fire, electric shock, and personal injury. These include: service center at 1-866-SNOWJOE (1-866-766-9563). • Know your product – Know how to stop the machine and WARNING! Do not use this appliance without reading bleed pressure quickly. Thoroughly familiarize yourself with this instruction manual.
Snow Joe ® ® ® manufacturer. + Sun Joe customer service center at 1-866-SNOWJOE ® (1-866-766-9563). WARNING! Water that has flowed through backflow preventers is considered to be non-potable. The following should be observed when connecting the...
3. Ground fault circuit interrupter (GFCI) protection – WARNING! To reduce the risk of electrocution, keep This pressure washer is provided with a ground-fault all connections dry and off the ground. Do not touch plug with circuit-interrupter (GFCI) built into the plug of the power- wet hand.
Product Description Purpose • This high-pressure electric power washer is intended for residential use only. It is designed for light-to-medium duty cleaning jobs on boats, motorcycles, RVs, ATVs, trailers, decks, barbecues, siding, patio furniture, and more. Areas of application • Never use the machine in potentially explosive areas under any circumstances! •...
Safety Symbols The following table depicts and describes safety symbols that may appear on this product. Read, understand, and follow all instructions on the machine before attempting to assemble and operate. Symbols Descriptions Symbols Descriptions READ THE OPERATOR'S MANUAL(S) – Read, understand, and follow all instructions in the WARNING! Electrical shock hazard.
Know Your Electric Pressure Washer Read the owner’s manual and safety rules carefully before operating the pressure washer. Compare the illustration below to the pressure washer in order to familiarize yourself with the location of the various controls and adjustments. Save this manual for future reference.
+ Sun Joe customer service center at ® ® Fig. 2 1-866-SNOWJOE (1-866-766-9563). NOTE: Do not discard the shipping carton and packaging Handle material until you are ready to use your new electric Large Phillips pressure washer. The packaging is made of recyclable head screws materials.
3. Slide the hose/cord holder into position (Fig. 3). Fig. 6 Fig. 3 Rear compartment Hose/ cord holder Small Phillips head screws 6. Fit the Quick-Connect spray wand into the trigger gun and 4. Slide the trigger gun holder into position (Fig. 4). twist the rotatable end-piece of the wand until the two parts are completely locked (Fig.
8. Connect the other end of the high-pressure hose to 10. Attach garden hose to water supply (Fig. 11). the water outlet on the pressure washer (Fig. 9). First, push the high-pressure hose end completely onto Fig. 11 the high-pressure water outlet, then screw it on clockwise. Tighten securely.
Page 11
12. Check that the electrical supply voltage and frequency 3. Turn the water supply tap on completely. (Volt/Hz) correspond to those specified on the pressure 4. Unlock the safety lock, then press the trigger for a few washer rating plate. If the power supply is correct, seconds until the water flow is steady.
Page 12
Using the Adjustable Jet Nozzle CAUTION! NEVER change nozzles without locking the safety lock on the trigger handle. WARNING! High-pressure jets can be dangerous if WARNING! High-pressure jets can be dangerous if subject to misuse. The jet must not be directed at persons, subject to misuse.
Using the 90º Angled Nozzle 2. Remove the cap. Fill the bottle or mix as recommended by detergent instructions (Fig. 22), and secure the cap back 90 degree angled nozzle directs the water into hard to reach into place. Replace it back on the unit. areas (Fig.
2. Turn off the water source. Fig. 25 3. Hold the trigger to release water pressure. 4. Disconnect the garden hose from the water inlet on Decrease Increase soap volume the unit. soap volume 5. Disconnect the high-pressure hose connection on the Adjustable cap trigger gun handle.
® requires service or maintenance, please call the Snow Joe Inlet filter ® Sun Joe customer service center at 1-866-SNOWJOE ® (1-866-766-9563). Model + Serial Numbers When contacting the company, reordering parts, or arranging service from an authorized dealer, you will need to provide the model and serial numbers, which can be found on the decal located on the housing of the unit.
• Pump seals worn out. • Please call the Snow Joe + Sun Joe customer ® ® service center at 1-866-SNOWJOE (1-866-766-9563) for assistance. Machine stops • Fuse has blown. • Replace fuse. Switch off other machines using the same circuit.
Page 17
Optional Accessories WARNING! ALWAYS use only authorized Snow Joe + Sun Joe replacement parts and accessories. NEVER use ® ® replacement parts or accessories that are not intended for use with this electric pressure washer. Contact Snow Joe + Sun Joe ®...
Page 18
NOTE: Accessories are subject to change without any obligation on the part of Snow Joe + Sun Joe to provide notice of such ® ® changes. Accessories can be ordered online at sunjoe.com or via phone by contacting the Snow Joe + Sun Joe customer ® ® service center at 1-866-SNOWJOE (1-866-766-9563).
Page 19
To obtain a replacement part or product, please visit warranty. Some states do not allow exclusions of incidental or snowjoe.com/help or email us at help@snowjoe.com for consequential damages so the above exclusions may not apply instructions. Please be sure to register your unit beforehand to in all states.
Need help?
Do you have a question about the Sunjoe SPX2004-RM and is the answer not in the manual?
Questions and answers