HP L1906i Technical Specifications page 11

QuickSpecs
Technical Specifications - HP LCD Monitor Quick Release
Mechanical Mechanical Mechanical Mechanical
Additional components Additional components Additional components Additional components
Color Color Color Color
NOTES NOTES NOTES NOTES:
Supported weight capacity The HP Quick Release has been designed to support a maximum of up to 24 lbs (10.9 kg) depending Supported weight capacity Supported weight capacity Supported weight capacity
© 2008 Hewlett-Packard Development Company, L.P.
Microsoft and Windows are trademarks or registered trademarks of Microsoft Corporation in the U.S. and other countries. Windows
Vista is either a registered trademark or trademark of Microsoft Corporation in the United States and/or other countries. ENERGY
STAR is a registered mark owned by the U.S. government. ENERGY STAR is a registered mark owned by the U.S. government.
HP shall not be liable for technical or editorial errors or omissions contained herein. The information is provided as is without
warranty of any kind and is subject to change without notice. The warranties for HP products are set forth in the express limited
warranty statements accompanying such products. Nothing herein should be construed as constituting an additional warranty. All
performance specifications represent the typical specifications provided by HP's component manufacturers; actual performance may
vary either higher or lower.
Dimensions (H x W x D) Dimensions Dimensions Dimensions
Weight Weight Weight Weight
Eight 10 mm mounting screws (for attachment to VESA compliant monitor mounts)
Eight 15.5 mm mounting screws (for attachment to HP Compaq t5000 Thin Client products)
Four 20 mm mounting screws (for attachment to back of select HP flat panel monitor stands)
One Quick Release "locking" screw
Carbonite
1.
No HP monitors allow positioning of a thin client product between a monitor screen and its stand.
2. The Quick Release device is not to be used between a monitor screen and its stand unless
provided that way from the factory.
3.
Under no circumstances is the Quick Release device intended to be used in an orientation where
the Release/Lock lever is oriented downward.
upon the mounting configuration used. Please note this is a total weight limit for all devices mounted,
i.e. the combined weight of the monitor and a second device such as an HP Thin Client cannot exceed
24 pounds. Because mounting surfaces vary widely and the final mounting method and configuration
may vary, mounting fasteners are not supplied (other than the VESA-compliant screws). HP recommends
that you consult with a qualified engineering, architectural or construction professional to determine the
appropriate type and quantity of mounting fasteners required for your application and to ensure that
your mounting solution is properly installed to support applied loads.
DA - 12762 North America — Version 4 — February 25, 2008
HP L1906i 19-inch LCD Monitor with IWC Stand HP L1906i 19-inch LCD Monitor with IWC Stand HP L1906i 19-inch LCD Monitor with IWC Stand HP L1906i 19-inch LCD Monitor with IWC Stand
Packaged: Packaged: Packaged: Packaged:
Unpackaged: Unpackaged: Unpackaged: Unpackaged:
Packaged: Packaged: Packaged: Packaged:
Unpackaged: Unpackaged: Unpackaged: Unpackaged:
7.8 x 6.25 x 1.5 in (19.8 x 15.9 x 3.8 cm)
6.3 x 5.2 x 0.65 in (16 x 13.2 x 1.65 cm)
1.1 lb (0.49 kg)
0.82 lb (0.37 kg)
Page 11