In the interest of safety, the VOH1042 DL should never be installed where it will be visible, directly or indirectly, by the operator of the motor vehicle.
Congratulations on your purchase of the Audiovox VOH1042 DL drop down TV/Video Monitor. • 10.4” TFT (Thin Film Transistor) Active Matrix LCD VOH1042 DL has been designed to give you and your (Liquid Crystal Display) Monitor family many years of video entertainment in the mobile •...
Page 4
All manuals and user guides at all-guides.com FRONT PANEL FEATURE Figure 1 CHANNEL VOLUME PIC. TV/AV SEL.
All manuals and user guides at all-guides.com FRONT PANEL FEATURES – See Figure 1 1. Power Button – (Bright red when system is ON, dim 7. TV/AV– Any video equipment connected to the AUDIO/VIDEO inputs can be used with the TV by when system is OFF).
MEMORY that proper polarity (+ or -) is observed. 3) Slide the cover back until it clicks into position. VOLUME The Remote Control will operate the VOH1042 DL, VCP POWER PLAY Audiovox Televisions and Video Media Players. It is not a universal remote control and will not control F.FWD...
Page 7
REMOTE CONTROLLED TV FUNCTIONS Headphones, or page 11, Wired FM Modulator). 1. POWER ON/OFF Press this button to turn the VOH1042 DL on. The 5. PICTURE SELECT BUTTON channel number or current video source will be Each time this button is pressed, the screen picture displayed on screen, and the picture will appear in adjustment display cycles through “adjustment...
Page 8
“RED”. Tape will fast forward. If this button is pressed while When skip mode is on, the VOH1042 DL will tune to the Video Tape is playing, the VCP will go into fast only the stored channels when using the CHANNEL forward search mode.
MANUAL MEMORY XX ADD is displayed on control unit or the AUTO PROGRAM (AP) button screen. on the flip down video unit. You will see the TV cycle through all the channels. The built-in TURNING THE VOH1042 DL ON AND OFF microprocessor will automatically store each channel that is actively broadcasting in your area.
A three-position slide switch controls the Dome The VOH1042 DL incorporates an Infrared Sensor, Lights on the VOH1042 DL. Sliding the switch to which relays the signals from the Remote Control to the ON position will turn the Dome Lights ON. The...
Once the connections have been made, turn the VOH1042 DL on and press the source button The VOH1042 DL has a Jack labeled “to FM on the VOH1042 DL or the TV/Video button on the Transmitter”, this Jack is for connection of an optional...
OFF will allow for normal radio reception. VIDEO OUTPUT The VOH1042 DL provides a video output for an optional Video monitor(s). This output will provide a video signal that duplicates the signal displayed by the VOH1042 DL to an additional Monitor or Video display.
All manuals and user guides at all-guides.com TYPICAL SYSTEM CONNECTIONS Antenna T ’ Negative Dome Light Switching Lamp Auto Purple/Brown Constant 12V Black/Red Lamp ON Red/Black Positive Dome Light Switching Lamp Auto Purple/Brown Ground Black/Red 12Vdc Red/Black Accessor PIN 1 – Power/Red Harness PIN 2 –...
All manuals and user guides at all-guides.com Troubleshooting Specifications LCD Brightness 300 nits (min) PROBLEM SOLUTION Poor TV Reception • Perform auto programming of Resolution SVGA 800 x 600 the tuner • Verify antenna condition. • NOTE: Due to the nature of TV Operation Temperature -10 ~ 65º...
Page 15
All manuals and user guides at all-guides.com AUDIOVOX ELECTRONICS CORP. (the Company) warrants to the original retail purchaser of this product that should this product or any part thereof, under normal use and conditions, be proven defective in material or workmanship within 36 months from the date of original purchase, such defect(s) will be repaired or replaced with reconditioned product (at the Company's option) without charge for parts and repair labor.