A&S TWS02SE Bluetooth Pairing Pairing your device for the first time: First step - Please make sure the headset is fully charged before starting pairing. The headphones and charging case are packaged separately. Second step - Remove the right earphone from the charging case and it will automatically enter pairing mode.
Page 4
A&S TWS02SE Bluetooth Pairing Third step - Go to the Bluetooth menu in your device. Select "A&S Batman" Make a connection The fourth step - Remove the left earphone from the charging case, It will automatically connect the right earphone.
A&S TWS02SE TWS Operation Clear Binaural Pairing Press and hold for 5 seconds to switch on manually Touch the left or right ear three times in unpaired mode (third press and hold for 3 seconds) Charging Case Status when using wireless charging...
A&S TWS02SE Precautions Avoid Hearing Damage WARNING: permanent hearing loss may occur if heaphones are used at high volume. Set the volume to a safe level. You can adapt over time to a higher volume of sound that may sound normal but can be damaging to your hearing. If you experience ringing in your ears of muffled speech, stop listening and have your hearing checked.
A&S TWS02SE FCC WARNING This device complies with part 15 of the FCC Rules. Operation is subject to the following two conditions: (1) this device may not cause harmful interference, and (2) this device must accept any interference received, including interference that may cause undesired operation.