Advertisement
Model: LNG1
Description: Radio Module, 915MHz ISM Band, FHSS Mesh Network
Sentient Part Number: 132-0004-01
Revision: 1
Date: May 7, 2014
Introduction
This document summarizes the requirements for properly incorporating the model LNG1 radio
module into Sentient products intended for marketing in the USA and Canada. The following
legally mandated requirements are specified:
1. Antenna type and use
2. RF exposure guidelines
4. End product User's Manual required text
Antenna Requirements - USA
The module has been certified for use with an Inverted F type antenna with a max gain of 3dBi.
The module may be used with any similar Inverted F type antenna whose max gain is 3dBi or
less. An antenna is considered similar (as used here) if it has a similar radiation pattern.
Antenna Requirements - Canada
Under Industry Canada regulations, this radio transmitter may only operate using an antenna of a
type and maximum (or lesser) gain approved for the transmitter by Industry Canada. To reduce
potential radio interference to other users, the antenna type and its gain should be so chosen that
the equivalent isotropically radiated power (e.i.r.p.) is not more than that necessary for successful
communication.
This radio transmitter IC: 9908A-LNG1 has been approved by Industry Canada to operate with
the antenna types listed below with the maximum permissible gain and required antenna
impedance for each antenna type indicated. Antenna types not included in this list, having a gain
Sentient Energy, Inc.
User's Manual
LNG1 Radio Module
880 Mitten Road, Ste 105
Burlingame, CA 94010
Phone: 650 523-6680
Fax: 650 648-0407
www.sentient-energy.com
Advertisement
Table of Contents
Summary of Contents for Sentient LNG1
- Page 1 (e.i.r.p.) is not more than that necessary for successful communication. This radio transmitter IC: 9908A-LNG1 has been approved by Industry Canada to operate with the antenna types listed below with the maximum permissible gain and required antenna impedance for each antenna type indicated.
- Page 2 End Product Labeling A statement must be included on the exterior of the final product which indicates the product includes a certified module. The product contains FCC ID: Z2E-LNG1 and IC: 9908A-LNG1 Contains FCC ID: Z2E-LNG1 Contains IC: 9908A-LNG1 The OEM must include the following statements on the exterior of the finished product unless the product is too small (e.g.
- Page 3 User’s Manual - LNG1 Radio Module Sentient Energy, Inc. End Product User’s Manual - USA The finished product manual must contain the following statement (or similar statement which conveys the same meaning): WARNING: Changes or modifications not expressly approved by the party responsible for compliance could void the user’s authority to operate the equipment...
- Page 4 User’s Manual - LNG1 Radio Module Sentient Energy, Inc. (2) this device must accept any interference, including interference that may cause undesired operation of the device. Le présent appareil est conforme aux CNR d'Industrie Canada applicables aux appareils radio exempts de licence. L'exploitation est autorisée aux deux conditions suivantes : (1) l'appareil ne doit pas produire de brouillage, et (2) l'utilisateur de l'appareil doit accepter tout brouillage radioélectrique subi, même si le brouillage est susceptible d'en...
Need help?
Do you have a question about the LNG1 and is the answer not in the manual?
Questions and answers