Advertisement
Quick Links
Visit push button transmitter
Buttons and connections
Status LED
Front button
Front cover
Technical specifications
In the box
BE1420 Visit push button transmitter
with pre-mounted PX28G/PX28M
6V alkaline battery
Lanyard with safety clasp
Adhesive tape, screws and plugs
Power and battery
Battery type
1
6 V PX28G/PX28M alkaline or
1
6 V PX28L lithium
Power consumption
Active < 35 mA
Idle position < 0.05 μA
Operation time
Alkaline battery ~ 2 years
Lithium battery ~ 5 years
Radio key switches
Signal switches
Pre-mounted battery
Dimensions and weight
Height: 66 mm, 2.6"
Width: 48 mm, 1.9"
Depth: 23 mm, 0.9"
Weight: 50 g, 1.8 oz. incl. battery
Activation
Via the front button
Environment
For indoor use and outdoor use
in a protected location. Will not
withstand water or rain. (IP42)
Operating temperature
-10° to 40° C, 14° to 104° F
Relative humidity
15% to 90%, non-condensing
Hole for lanyard
Adhesive tape
2
hole markings
Frequency and coverage
Frequency: 315 MHz, 433.92 MHz or
868.3 MHz, depending on region
Coverage by region:
315 MHz: Up to 50 m (164 ft)
433 MHz: 30 – 80 m (98 - 260 ft)
868 MHz: 50 – 250 m (55 - 273 yd)
Coverage depends on the radio
frequency, building's characteristics
and the combination of transmitters
and receivers.
Maintenance and cleaning
Maintenance free
Clean with a dry cloth
Do not use household cleaners,
aerosol sprays, solvents, alcohol,
ammonia or abrasives
BE1420
Advertisement
Related Manuals for Bellman BE1240
Summary of Contents for Bellman BE1240
- Page 1 Visit push button transmitter BE1420 Buttons and connections Status LED Front button Radio key switches Signal switches Hole for lanyard Front cover Pre-mounted battery Adhesive tape hole markings Technical specifications In the box Dimensions and weight Frequency and coverage BE1420 Visit push button transmitter Height: 66 mm, 2.6"...
- Page 2 Clean the wall with the wet wipe and remove the protective film from the tape. Mount the unit in a weather protected area by the front door. www.bellman.com Bellman Visit 868 Pushbutton transmitter Model: BE1420 Frequency 868,3 MHz Battery: 1 x 6V Made in P.R.C. by Bellman & Symfon AB, Sweden...
- Page 3 Visit push button transmitter Testing the connection Using the front button Press the front button on the transmitter. The LED lights up in green to show that a radio signal is being transmitted. The green Visit LED on the receiver lights up to show that the signal was received.
- Page 4 Visit push button transmitter Changing the radio key If your Visit system is activated for no reason, there is probably a nearby system that triggers yours. In order to avoid radio interference you need to change the radio key on all units. The radio key switches are located under the transmitter cover. Here is how you change the radio key: Remove the transmitter front cover and move any radio key switch to the up (on position) to change the radio key.
Need help?
Do you have a question about the BE1240 and is the answer not in the manual?
Questions and answers