Recording And Play Back - Casio CDP-S160 User Manual

Digital Piano Operation

Recording and Play Back

You can store the notes you play in Digital Piano memory for
later playback.
● Memory Capacity
• You can record approximately 2,500 notes in Digital Piano
memory.
• The 4 RECORD button lamp will flash at high speed
when memory runs low.
• Recording stops automatically if the number of notes in
memory exceeds the maximum.
● Recorded Data
• Keyboard play
• Keyboard tone (including layered tone)
• Pedal operations
• Reverb and chorus settings
• Tempo setting
• Transpose setting
• Duet Mode setting (Off, On, Pan), duet keyboard registers
• Digital Piano settings cannot be changed while recording is
in progress.
● Recording Data Storage
• Starting a new recording deletes any data that was
previously recorded in memory.
• If power to the Digital Piano is cut off while recording is in
progress, everything you recorded up to that point will be
deleted. Take care so power is not turned off accidentally
during recording operations.
• CASIO COMPUTER CO., LTD. takes no responsibility
for any damages, lost profits, or claims by third parties
arising from the deletion of recorded data due to
malfunction, repair, or for any other reason.
EN-14
■ To record keyboard play
1.
Long-press 4 RECORD until the button's
LED starts to flash.
• The flashing 4 RECORD button LED indicates that
the Digital Piano is in record standby.
• To exit record standby, long-press 4 RECORD
again until the LED goes out.
2.
To start recording, play something on the
keyboard, press the pedal, or press 4 a.
• During recording, the LED stops flashing and remains
lit.
3.
To finish recording, press 4 a.
The LED will turn off after the recording save operation is
complete (which may take a little time).
■ To play back a recorded performance
1.
Press 4 a.
This starts playback of what you recorded.
• During playback of a recorded song the 4 RECORD
button LED flashes at the tempo of the recording.
2.
To stop playback, press 4 a again.
• Playback will stop automatically when the end of the
recording is reached.
Flashing