Stealth Cam STC-PX18CMO Instruction Manual page 10

CAMERA PROGRAMMING -­‐ CUSTOM (CONT)
RESOLUTION – (MED default): This setting is used to determine the megapixel resolution of each
image taken by the camera. This is only for PHOTO mode. Use the UP or DOWN arrow key to
move between the options of: 8MP(HI), 4MP(MED), 2MP(LO). The higher the resolution of an
image the more space the file will take on the SD memory card. Press the ENTER button to accept
all your changes and to go back to main options menu.
DELAY -­‐ (5SEC default): This setting is used to determine the length of time that the camera will
wait before it reinitializes its PIR sensor for the next activation. Use the UP and DOWN arrows to
choose how many seconds you want the delay to be set for -­‐ 120S / 60S / 30S / 15S / 10S / 5S.
Once this setting is on the appropriate time, press the ENTER button to accept all your changes
and to go back to main options menu.
BURST – (1P default): This setting is used to determine the number of photos the camera will take
during its activation. This setting can be changed between 1 PHOTO up to 6 PHOTOS. Use the UP
or DOWN arrow key to move between the value range in increments of 1. Press the ENTER button
to accept all your changes and to go back to main options menu.
VIDEO LENGTH – (15SEC default): This setting is used to determine the length of time, in seconds,
of the video recording. This setting can be set to either 30S / 15S / 5S. Use the UP or DOWN
arrow key to make your selection. Press the ENTER button to accept all your changes and to go
back to main options menu.
10
www.stealthcam.com Page
877-­‐269-­‐8490