Ventair Sahara Installation Instructions

Sahara
Fan Heater, Light and Exhaust
Please read these instructions carefully before installing and using the product. Keep the instructions handy for future reference.
Electrical wiring must only be done by a licensed electrician and a "Certificate of Compliance" must be issued on completion of the
installation.
OPERATING INSTRUCTIONS AND HELPFUL HINTS
Fan
Please note: 'Fan' must be switched on before Heat function can operate.
• Use 'Fan' only (without 'Heat') for cooling effect in warmer weather.
Heat
Please note: 'Heating Functions' will only operate after 'Fan' has been switched on.
• Stand directly underneath the fan heater for maximum heating effect.
• In cooler weather, turn the heater on 5 to 10 minutes before having a bath or shower. This will warm the
environment, helping to minimise steam production and condensation on the mirrors and walls.
• In high steam conditions, use the exhaust function in tandem with the heat function to maximise steam
removal.
Exhaust
• For maximum exhaust performance, there must be sufficient replacement intake air available through either an ajar door, an
adequate size gap underneath the door or an air vent in the door.
• In high steam conditions, run exhaust for several minutes after leaving the bathroom to help with condensation and moisture control.
WHAT'S IN THE BOX
• Bathroom unit
• Operating and Installation Instructions
• Five Switch Wall Plate
• Cutout Template
SAFETY INSTRUCTIONS
During use of the product, it is necessary to observe some precautions. Improper operation with disregard of precautions may result in
infliction of harm to health of the user and other people, as well as infliction of damage to their property.
• Use only the voltage specified on the rating plate of the heater.
• This item should only be installed by a licensed tradesperson.
• The heater should be connected to the electric mains equipped with an automatic circuit breaker.
• The unit must be handled with care avoiding any sudden impacts or vibrations.
WARNING: FIRE RISK EXISTS IF THE HEATER IS COVERED BY OR POSITIONED CLOSE TO
• Do not use the appliance in areas where gasoline, paint or other flammable liquids are used or stored.
• Do not use the appliance in dusty areas or where explosives are stored.
• Do not use the appliance in a building site, green house, barn or in animal stables.
• Do not use the appliance as a sauna heater.
• Warning: To avoid risk of burns, do not touch the appliance while in operation or until fully cooled following operation (up to 1 hour).
Electricians, please ensure a copy of the Installation
Instructions are left with the end user for future reference
CURTAINS OR OTHER COMBUSTIBLE MATERIALS.
Installation Instructions
EXHAUST LIGHT
FAN
HEAT I HEAT II
Page 1 of 5