Advertisement
2 Device Resting Plate
2 Extension Arm
2 Folding Tripod Base
8 Washers
4 Mounting Clamps
8 Wing Nuts
8 Plate Bolts
Slide the metal mounting clamps onto both ends of the
extension arm. Each side is tted with rubber grips that the
clamps use for holding support. Be sure as to, at least partially,
slide the metal mounting clamps to lay over the rubber grips.
Use the dual clamp-style knobs on both sides on each of
the mounting clamps to secure the angle and placement of
the device resting plate.
Use the included hardware to secure the device resting
plate with the metal mounting clamps. The holes in the
mounting clamp brackets should align with the holes
protruding through the base plate. Be sure to use a washer
between the wing nut and the metal mounting clamp
when securing.
The plate bolts are to be inserted from the top of the unit,
going downward through the device resting plate, and out
of the other end to meet the metal mounting brackets.
The metal mounting bracket clamps can be adjusted or
loosened accordingly to allow for angle/tilt adjustment.
2
www.PyleUSA.com
Advertisement
