Table of Contents
Advertisement
Reference
Publications
Standards
ANSI/NEMA MG-2
Safety Standards for construction
and
installation and Use of Electric
Motors and Generators.
ANSI C50.10
General
Synchronous Machines.
IEEE 1
General
Temperature Limits in Rating of
Electrical Equipment.
IEEE 85
Test Procedure for Air-borne
Noise Measurements on Rotating
Machinery.
IEEE 112
Test Procedure for Polyphase
Induction Motors and Generators.
IEEE 115
Test Procedures for Synchronous
Machines.
4
GE Energy Motors GEEP-427-I
GEEP-427-I Pegasus, Horizontal Induction Motor
and
Guide
for
Selection,
Requirements
for
Principles
for
TEWAC, Sleeve Bearing
Standards can be obtained by writing to the following:
National Electrical Manufacturers Association
2101 Street, N.W.
Washington, DC 20037
American National Standards Institute
1430 Broadway
New York, NY 10018
Attention: Sales Department
The Institute of Electrical and Electronics Engineers,
Inc.
445 Hoes Lane
Piscataway, NJ 08854
Attention: Publication Sales
Warranty considerations
The
warranty
equipment specified under "Identification of Unit" may
be found in the corresponding sales contract.
The equipment must be operated in accordance
with nameplate specifications, applicable standards and
codes, and in accordance with this instruction manual for
the warranty to remain in effect during the warranty
period.
If a question or circumstance not covered by the
instruction manual occurs, or should a problem occur,
contact the nearest General Electric Technical Service
representative.
Copyright 2009, The General Electric Company, USA
coverage
applicable
to
the
Advertisement
Table of Contents
