Table of Contents
Advertisement
Installation
en
5Installation
F itting the upper support frame
I n s t a l l a t i o n
Before fitting, determine the total height of the
1.
support frame and mark the screw holes.
The height of the support frame can be
Note:
adjusted in 20 mm intervals.
On the ceiling, mark the centre point of the
2.
appliance.
Using the enclosed template, mark the positions for
3.
the screws on the ceiling.
Drill four 8 mm diameter holes to a depth of 80 mm
4.
for the fasteners and press in the wall plugs flush
with the ceiling.
Fasten the upper part of the support frame to the
5.
ceiling with 4 screws.
Ensure that the support frame is in the correct
Note:
position. The middle bracket defines the preferred
side and must be facing the hob control elements.
14
THE EASIEST WAY TO SELF-IMPORT APPLIANCES DIRECT FROM EUROPE.
Fitting the lower support frame
Fasten the upper and lower part of the support frame at
the specified total height using 10 screws.
Notes
Ensure that the lower support frame is in the correct
■
position. The open side must be facing the hob
control elements.
The support frame can be subsequently re-
■
positioned by loosening the securing screws.
Advertisement
Table of Contents
