Advertisement
Note:
The LAN connected computer must have an IP address in the same network
range (192.168.0.xxx) as the console server. If this is not convenient, you
can use the
online FAQ for details). The console server also has its DHCP client enabled
by default, so it will automatically accept any network IP address assigned by
any DHCP server on your network – and will then respond at both
192.168.0.1 and its DHCP address.
Log in using the default system user name
default,
Select System: Administration, enter and confirm a new System Password
and click Apply
To assign your console server a static IP address or to permanently enable
DHCP, select System: IP then Network Interface and check DHCP or Static
for Configuration Method
Step 4
Select Serial & Network: Serial Port to display the label, mode and protocol
options currently set for the serial port – by default, the serial port is set to
Console Server mode (refer the
To configure the serial port, click Edit
Configure the Common Settings (Baud Rate, Parity, Data Bits, Stop Bits and
Flow Control) to match those of the device being controlled
Select the Console Server protocols (Telnet, SSH, TCP and RFC2217) that are
to be used for the data connection to the serial port
A Logging Level may also be set to specify the level of information to be
logged and monitored for the serial port
CM4001 Quick Start (520006-Rev 3.2)
ARP Ping
command to set the IP address (refer
a Welcome screen listing the basic configuration steps is displayed
Configure serial & network devices
root
User Manual
if other modes are required)
User Manual
and the default password
or
Page 2
Advertisement
