Advertisement
5. OPERATION
5.1. Made sure that loading is carried out on a hard, level and stable surface with the vehicle in gear, the parking/emergency brake on and the
engine switched off.
5.2. Unfold and place the lip edge of the ramp against the tailgate of the vehicle. (Tailgate should be no more than 76cm in height or the incline
will be too steep.
5.3. Secure the ramp to the vehicle being loaded using the chain. Test the ramp by pulling backwards on it. Make sure it does not slide back or
disengage from the loading surface.
5.4. Once the ramp is secure and the area is safe to proceed with loading, move the vehicle to be loaded behind the ramps and centre the load
between both ramp rails.
5.5. Load the vehicle, make sure that the ramp is sustaining the load and not bowing from the weight.
5.6. Continue until the vehicle is fully loaded. Secure and then tie down the load.
5.7. Unhook the chain and fold the ramp.
5.8. Store in a clean, dry and childproof environment.
ENVIRONMENT PROTECTION
Recycle unwanted materials instead of disposing of them as waste. All tools, accessories and packaging should be sorted, taken to
a recycling centre and disposed of in a manner which is compatible with the environment. When the product becomes completely
unserviceable and requires disposal, drain any fluids (if applicable) into approved containers and dispose of the product and fluids
according to local regulations.
Note: It is our policy to continually improve products and as such we reserve the right to alter data, specifications and component parts without prior
notice.
Important: No Liability is accepted for incorrect use of this product.
Warranty: Guarantee is 12 months from purchase date, proof of which is required for any claim.
Sealey Group, Kempson Way, Suffolk Business Park, Bury St Edmunds, Suffolk. IP32 7AR
01284 757500
© Jack Sealey Limited
01284 703534
sales@sealey.co.uk
Original Language Version
www.sealey.co.uk
FCR500 Issue 2(1,2,5) 13/09/21
Advertisement
