Table of Contents
Advertisement
H
I
ARDWARE
NSTALLATION OF
Installing the DVD Writer
This chapter explains how to physically install your DVD writer in your computer.
The steps you need to perform are as follows:
1.
Turn off your computer system and unplug it from the power outlet.
2.
Remove the computer cover.
3.
Set the Master/Slave jumper on the rear panel of the DVD writer,
following the instructions below.
NOTE: To get the best results from your hard disk drive and your DVD writer,
we recommend that you connect the DVD writer to the secondary IDE port as
the Master device, as described below.
ATAPI/E-IDE D
10
ENGLISH
RIVES
Advertisement
Table of Contents
