Installation; Scope Of Delivery; Wall Mounting - AEG WALLBOX WB 11 Installation Instructions Manual

Environmental conditions
Model
Ambient temperature
Storage temperature
Max. humidity
Max. height above sea level

4. INSTALLATION

Warning of dangerous electrical voltage!
Touching electrical cables can result in a fatal electric shock.
• The charging station may only be installed and fused by a
qualified electrician.
• The charging station may only be installed in purely resi-
dential areas.
• Observe local safety regulations and legal requirements.

4.1 Scope of delivery

• Pre-assembled charging station housing with charging cable
• Drilling template
• 3 universal dowels
• 3 washers
• 3 seals
• 3 fastening screws
• Installation instructions
• Operating Instructions

4.2 Wall mounting

1. Use the enclosed drilling template to mark the 3 drill holes on the
wall. Make sure that the drilling template is correctly aligned.
2. Drill the marked 3 holes, Ø 8 mm, approx. 60 mm deep.
3. Insert the dowels into the drill holes. The dowels are 8 mm universal
dowels.
If the universal dowels are not suitable for fixing the charg-
ing station to the intended wall, use other plugs.
4. Loosen the 7 screws on the sides and top of the housing.
5. Carefully detach the cable from the LED board and put the cover
aside.
6. Hold the open charging station against the wall with one hand so
that the mounting holes are over the drill holes.
7. Place the washers and seals and secure the charging station with
the 3 screws provided. Be careful not to damage the components
inside the charging station.
8. Do not release the charging station until all 3 screws are firmly
tightened.
211012_11201_11203_AEG_Montage-BDA_A4.indd 19 211012_11201_11203_AEG_Montage-BDA_A4.indd 19
Wallbox 11
-40 °C - 45 °C
-40 °C - 70 °C
5 % - 95 %, non-condensing
2000 m
English
Wallbox 22
14.10.21 14:43 14.10.21 14:43
19