Advertisement

Quick Links

USER MANUAL V1.1

Advertisement

Table of Contents
loading
Need help?

Need help?

Do you have a question about the ST16 and is the answer not in the manual?

Questions and answers

Subscribe to Our Youtube Channel

Summary of Contents for TYPHOON ST16

  • Page 1 USER MANUAL V1.1...
  • Page 2: Table Of Contents

    - ADDITIONAL FUNCTIONS NOTICES AND WARNINGS FLIGHT CONTROLS (TEAM MODE) GENERAL SAFETY PRECAUTIONS AND WARNINGS TEAM MODE ( TWO ST16 Ground Stations ) LIPO BATTERY WARNINGS AND USAGE GUIDELINES TEAM MODE (WIZARD™ & ST16) DISCLAIMER WIZARD BUTTON COMBINATION FUNCTIONS CERTIFICATION INFORMATION...
  • Page 3: Introduction

    INTRODUCTION Typhoon H is an advanced aerial photography and videography platform, perfect for skilled pilots and photographers alike. It offers up to 25 minutes OVERVIEW Power Switch Sonar Camera LED Status Indicator CGO3+ Gimbal Camera Camera Lens 5.8GHz Antenna...
  • Page 4: Specifictations

    SPECIFICTATIONS TYPHOON H SPECIFICATIONS Flight Time Up to 25 min Takeoff Weight Battery ( ) Transmitter Maximum Flying Height CGO3+(CGO3 PLUS) SPECIFICATIONS Weight ST16 GROUND STATION...
  • Page 5: Placement Before Takeoff

    CHARGING PLACEMENT BEFORE TAKEOFF lighter receptacle in a vehicle using the included adapter. power hours to charge a fully discharged fully charged. ASSEMBLY Unfold the motor arms and secure them until hearing a 'click'. to fold the motor arms.
  • Page 6: Powering On / Off

    POWERING ON / OFF ,press and rotate propel and rotate the propeller in the direction the [ ] points to, propellers. position. STARTING/STOPPING THE MOTORS motors to stop the motors. e protective cover from the camera lens. Insert the motors.
  • Page 7: Flight Controls (Single Mode)

    FLIGHT CONTROLS (SINGLE MODE) ST16 OVERVIEW Gimbal Pan Mode (Follow Mode/Follow Pan Controllable Mode/Global Mode) Gimbal Tilt Mode (Angle Mode/ Velocity Mode) Gimbal Pan Control Rudder/Yaw Control (Mode 2 and Mode 1) Throttle/Altitude Control ( Mode 2) Elevator/pitch control (Mode 1)
  • Page 8 home point and land. from touching the direction controls as this can cause the aircraft to tip over. H immediately. activated. is pointed. control sticks are centered. You can also activate motor stops.
  • Page 9: Flight Modes

    - HOME When th the camera to keep tracking the remote controller no matter Watch [ Typhoon H to positioning completes, and Typhoon H is default limit at all times. SMART CIRCLE there is no extra operation on the ,...
  • Page 10 When the LANDING LOCATION activate Home Mode until Typhoon H automatically (4-8m) PILOT LOCATION If you do not properly control Mode. If the signal of remote control is lost, With susta until it lands. green. If t 10 m Typhoon...
  • Page 11 BACK RESET LIST SAVE START Tap the [ automatically. VOLTS PONINT 1 PONINT 1 PONINT 2 ANGLE PONINT 3 INSTRUCTION N/AE RESET: Delete all waypoints Make sure the H is clear of all N/AN obstacles before starting mission. Disabled +/-: Add/Delete a waypoint LIST: Load existing waypoint N/AV SLIDE TO START...
  • Page 12 around the pilot. and the pilot as the radius. the pilot tap the [ ], the center point as the radius.
  • Page 13: Flight Controls (Team Mode)

    FLIGHT CONTROLS (TEAM MODE) PILOT WIZARD™ CAMERA OPERATOR ST16 Wizard™ Power LED : (yaw can’t be controlled) Start/Stop Video Recording Button...
  • Page 14 TEAM MODE (Wizard™&ST16) TEAM MODE ( TWO ST16 Ground Stations ) the camera to align. Tap the settings icon [ ] an mode. directions. mode to single mode. successful.
  • Page 15: Wizard Button Combination Functions

    WIZARD BUTTON COMBINATION FUNCTIONS ( ). Turn off/on altitude Switch between Watch Me/ follow function Follow Me function rapidly. PRESS -                             -  PRESS • •             -              -    Watch Me FLIGHT CONTROLS     Landing gear up/down             -  PRESS             -  PRESS             -  90°...
  • Page 16 When When in pilot ( ) same time is yello green. safe distance( When t When When the LANDING Watch keep When t LOCATION PILOT LOCATION In Home ] to accelerate the landing speed. to take photos or record videos.
  • Page 17: Camera Controls

    CAMERA CONTROLS SINGLE MODE There is There is middle position decides the velocity rate, the further distance, the TEAM MODE you can take another. to avoid data loss. Button A = Take Still Photo Button B = Start/Stop Recording Video...
  • Page 18 VOLTS Auto ANGLE Auto N/AE N/AN Disabled N/AV ISO 32 1/250s CALIBRATION N/Am G-SPD FOLLOW WATCH N/A KPH To Take TASK N/Am CAMERA In the [ Auto Auto manually or automatically. Auto manually. video. When entering the photo capturing mode, video recording capture still photos.
  • Page 19: Create A New Model

    outdoors in open areas that are free from people, vehicles and other structions, near or under dense vegetation, structures or indoors. Do CREATE A NEW MODEL...
  • Page 20: Gui Instruction

    GUI INSTRUCTION mend to keep the default settings. Device Information time.
  • Page 21: Calibration

    CALIBRATION CAUTION: they are connected correctly. If they are not connected correctly, the telemetry CALIBRATION e until the separately, Turn the aircraft l the t s turn off. to the left again and then turn it for Yuneec service center.
  • Page 22: Update

    UPDATE connected. connected. tone. Yuneec service center.
  • Page 23: Led Status Indications

    LED STATUS INDICATIONS LED STATUS INDICATIONS DURING STARTUP Main LED Status Indicator ( ) LED STATUS INDICATIONS BEFORE/DURING FLIGHT Main LED Status Indicator e Mode Below Motor Led Status Indicators LED STATUS INDICATIONS FOR CALIBRATION MODES Main LED Status Indicator CGO3+ CAMERA LED STATUS INDICATIONS...
  • Page 24: Wizard™ Led Status

    Wizard™ LED STATUS NOTICES AND WARNINGS IMPORTANT NOTE: All safety precautions and warnings, instructions, warranties and other collateral information is subject to change at the sole discretion of Yuneec. For the most up-to-date information please visit the corresponding product page at www.Yuneec.com or contact the nearest Yuneec office or authorized distributor.
  • Page 25: General Safety Precautions And Warnings

    GENERAL SAFETY PRECAUTIONS AND WARNINGS WARNING: Failure to use this product in the intended manner as described in the quick start guide and instruction manual can result in damage to the product, property and/or cause serious injury. A Radio Controlled (RC) multirotor aircraft, APV platform, drone, etc. is not a toy! If misused it can cause serious bodily harm and damage to property.
  • Page 26: Lipo Battery Warnings And Usage Guidelines

    LIPO BATTERY WARNINGS AND USAGE GUIDELINES WARNING: Lithium Polymer (LiPo) batteries are significantly more volatile than alkaline, NiCd or NiMH batteries. All instructions and warnings must be followed exactly to prevent property damage and/or serious injury as the mishandling of LiPo batteries can result in fire. By handling, charging or using the included LiPo battery you assume all risks associated with LiPo batteries.
  • Page 27: Disclaimer

    DISCLAIMER Yuneec Electric Aviation cannot be held liable for any damage, injury or for use of the product in violation with legal regulations, especially in the following circumstances: Damage and/or injury as well violation of legal regulations resulting from a failure to comply with the operating instructions or the instructions at www.yuneec.com, product information, user manual and other legally binding information.
  • Page 28: Certification Information

    CERTIFICATION INFORMATION FCC STATEMENT: This equipment has been tested and found to comply with the limits for Part 15 of the FCC rules. These limits are designed to provide reasonable protection against harmful interference in a residential installation. This equipment generates, uses and can radiate radio frequency energy and, if not installed and used in accordance with the instructions, may cause harmful interference to radio communications.
  • Page 29 CUSTOMER SERVICE DISTRIBUTOR: MANUFACTURER: US: Yuneec USA Inc. Yuneec International (China) Co., Ltd. CN: Youyu (Shanghai) Digital Technology Co.,Ltd. EU: Yuneec Europe GmbH Address: 5555 Ontario Mills Production Address: Address: B 15F, 461 HongCao Road,CaoHeJing Address: Niklaus–Otto-Strasse 4, Parkway, Ontario, CA91764, USA East Zhengwei Road No.388, Jinxi Software Building XuHui District, Shanghai, China 24568 Kaltenkirchen, Germany.

Table of Contents