Inserting/Removing Batteries Only Code’s CRA-B710 batteries are compatible with the CR7010 case. Insert the CRA-B710 battery into the cavity on the back side of the case; it will click into place. To verify the battery is properly connected, a lightning bolt will be located on the iPhone’s battery, signifying a charge status and successful battery installation.
The battery can also be charged within the CR7010 case via Code’s micro-USB cable (CRA-C34). The case will charge faster if the USB cable is plugged into Code’s USB wall adapter (CRA-P4). It will take approximately 3 hours to fully charge using this method.
Code Corporation. Code Corporation does not warrant that it is accurate, complete or error free. Any use of the technical documentation is at the risk of the user. Code Corporation reserves the right to make changes in specifications and other information contained in this document without prior notice, and the reader should in all cases consult Code Corporation to determine whether any such changes have been made.
Need help?
Do you have a question about the Code Reader 7010 and is the answer not in the manual?
Questions and answers