Sharp R-1211 Service Manual page 18

R-1210
R-1211
Pin No. Signal I/O
25 P41 OUT
26 P40 IN
27 IN
RESET
28-29 P71-P70 OUT
30 XIN IN
31 XOUT OUT
32 VSS IN
33 P27 OUT
34 P26 OUT
35 P25 OUT
36 P24 OUT
37 P23 OUT
38 P22 OUT
39 P21 OUT
40 P20 OUT
41 P17 OUT
42 P16 OUT
43 P15 OUT
44 P14 OUT
45-47 P13-P11 OUT
Terminal not used.
Connected to GND through the pull-down resistor R100.
Auto clear terminal.
Signal is input to reset the LSI to the initial state when power is applied.
Terminal not used.
Internal clock oscillation frequency input setting.
The internal clock frequency is set by inserting the ceramic filter oscillation circuit with
respect to XOUT terminal.
Internal clock oscillation frequency control output.
Output to control oscillation input of XIN.
Power source voltage: -5.0V.
VC voltage of power source circuit input.
Key strobe signal.
Signal applied to touch-key section. A pulse signal is input to P43-P46 terminal while one
of G8 line keys on key matrix is touched.
Key strobe signal.
Signal applied to touch-key section. A pulse signal is input to P43-P46 terminal while one
of G7 line keys on key matrix is touched.
Key strobe signal.
Signal applied to touch-key section. A pulse signal is input to P43-P46 terminal while one
of G6 line keys on key matrix is touched.
Key strobe signal.
Signal applied to touch-key section. A pulse signal is input to P43-P46 terminal while one
of G5 line keys on key matrix is touched.
Key strobe signal.
Signal applied to touch-key section. A pulse signal is input to P43-P46 terminal while one
of G4 line keys on key matrix is touched.
Key strobe signal.
Signal applied to touch-key section. A pulse signal is input to P43-P46 terminal while one
of G3 line keys on key matrix is touched.
Key strobe signal.
Signal applied to touch-key section. A pulse signal is input to P43-P46 terminal while one
of G2 line keys on key matrix is touched.
Key strobe signal.
Signal applied to touch-key section. A pulse signal is input to P43-P46 terminal while one
of G1 line keys on key matrix is touched.
Hood lamp driving signal.
To turn on and off relay(RY6). "L" level: During
Hood lamp ON. "H" level: During Hood lamp OFF.
Hood lamp driving signal.
To turn on and off relay(RY5). "L" level: During
Hood lamp ON. "H" level: During Hood lamp OFF.
Hood motor high / low driving signal.
To turn on and off relay(RY3). "L" level: During Hood
motor high. "H" level: During Hood motor low.
Hood motor driving signal.
To turn on and off relay(RY4). "L" level: During
Hood motor ON. "H" level: During Hood motor OFF.
Terminal not used.
16
Description