Westinghouse Q75AD1425-06 Quick Start Manual page 2

OPERATION
Before the solar security light can operate to its full capacity, the solar panel needs to be in sunlight for 8-12 hours to fully
charge the battery. Turn the light switch to the "OFF" position. After charge, turn the light switch to "ON" position.
•Adjust the motion sensor head toward desired detection area.
•Turn the light switch to "ON" position, the light can be used as a standard light.
NOTE:
Avoid aiming the control at:
•Objects that change temperature rapidly to prevent false triggering, such as heating vents
and air conditioners.
•Moving objects such as trees and street tra c.
OPERATION
TROUBLESHOOTING
PROBLEM
Lights will not come on.
Lights ash on and o .
Lights come on for no
apparent reason.
For additional help and information regarding installation, contact Customer Service at 1-844-551-0680, 8am-5pm, CST Monday – Friday
REPLACING THE BATTERIES
Use a Phillips head screwdriver to remove the 6 screws holding the battery cover in place.
Gently pull battery pack away from the light xture and disconnect the battery connector.
Replace old battery pack with a new 6V AA Ni-Mh 2000mAh rechargeable battery pack.
Connect the battery connector and insert battery pack into the light xture.
Replace the battery cover by aligning it properly and replacing the 6 screws removed earlier.
!
WARNING:
explode. Do not open, short circuit, or mutilate batteries. Dispose of batteries in accordance
with Local, State, and federal regulations. Contains no toxic metals. Do not mix old and new
batteries. Do not mix alkaline, standard (Carbon-Zinc), or rechargeable (Nickel Cadmium or
Nickel Hydride) batteries with Lithium batteries.
POSSIBLE CAUSE
A. Light switch is turned o .
B. Cable connection is loose.
C. Motion sensor head is not aimed correctly.
A. Low battery. .
A. Motion sensor maybe sensing moving objects
such as trees, tra c, etc.
B. Heat being re ected from other objects may
be turning the motion sensor on and o .
customerservice@qx-usa.com
, WESTINGHOUSE, are trademarks of Westinghouse Electric Corporation. Used under license by Sky Rich Star Limited. All Rights Reserved.
Do not dispose batteries in municipal waste stream or by fire as batteries may
A. Turn light switch to ON.
B. The Solar Panel needs to be in sunlight for 8-12 hours
to fully charge the battery.
C. Re-aim the motion sensor to cover the desired area.
A. With light switch set to "OFF", allow to charge in full
sunlight for 8-12 hours before further use.
A. Reposition motion sensor.
B. Reposition motion sensor.
ITEM: Q75AD1425-06
SOLUTION
05/09/2017
2/2 E