Max Systems LabelMax VS1 Quick Installation Manual

1. Insert the right side of the ribbon first.
Then, insert the left side to the hole
at the left side of ribbon rewind hub
(green).
2. Press the print head release button to
open the print head mechanism.
3. Insert the right side of the ribbon
supply spindle (marked "R") to the
ribbon supply hub first. Then, insert
the left side of ribbon supply spindle
to the hole at the left side of the
ribbon supply hub (green).
4. Pull the leader of the ribbon through
the print head and stick the leader of
the ribbon onto the ribbon rewinding
role.
5. Turn the ribbon rewind hub until the
ribbon plastic leader is thoroughly
wound and the black section of the
ribbon covers the print head. Wrap
the ribbon around the ribbon rewind
hub (green) at least 5 times.
6. Close the print head mechanism
with both hands and make sure the
latches are engaged securely.
MAX Systems GmbH
Quick Installation Guide

Loading the ribbon

1
3
6
| Am Bauhof 12 | 27442 Gnarrenburg
Prepare and
set up the printer
Place the LabelMax on a flat,
secure surface, then follow the
steps bellow:
1. Open the case
2. Turn on the LabelMax with the blue main
switch
3. The printer is ready to print and the Wi-Fi
connection is established within a minute.
A Wi-Fi connection is established with the
printer name and the last digits of the serial
number of the LabelMax. For example,
LabelMaxVS1-12345
4. Wi-Fi connection password: labelmax
5. The device is prepared in such a way that
you can print immediately after you have
connected to the printer via the Wi-Fi network.
Ready to Print!
2a
4+5
Ribbon loading path
Ribbon
Top sensor
Gap sensor
Platen roller
| + 49 (0) 47 63-9 45 95-0 | www.maxsystems.de
2b (open)
Ribbon rewind
Print head
| info@maxsystems.de
Media
Media guides