Table of Contents
Advertisement
GEM 2 Module Hardware Integration Guide
Tape and Reel Information
TBD
Soldering Guidelines
See the Stencil pattern above for solder paste application. Recommended Stencil thickness
is 120um.
Regulatory & Standards Information
FCC & Industry Canada
The GEM 2 module has modular approval for the United States and Canada. To ensure
compliance when using the GEM 2 module in a design, the OEM is required to adhere to the
implementation considerations supplied in this hardware integration guide.
Federal Communication Commission (FCC) Radiation Exposure Statement:
This device is in compliance with SAR for general population/uncontrolled exposure limits
in ANSI/IEEE C95.1‐1999 and had been tested in accordance with the measurement
methods and procedures specified in OET Bulletin 65 Supplement C.
This transceiver must not be co‐located or operating in conjunction with any other antenna,
transmitter, or external amplifiers. Further testing / evaluation of the end product will be
required if the OEM's device violates any of these requirements.
The GEM 2 Module is fully approved for mobile and portable applications.
FCC Labeling Requirements
WARNING: The OEM must ensure that FCC labeling requirements are met. This includes a
clearly visible label on the outside of the OEM enclosure specifying the appropriate FCC
identifier is visible.
Contains
FCC ID: PADWF116
IC: 10563A‐WF116
If OEM device is larger than 8x10cm, the following FCC part 15.19 statement has to be
visible on outside of device:
The enclosed device complies with Part 15 of the FCC Rules. Operation is subject to the
following two conditions: (1) This device may not cause harmful interference, and (2) This
device must accept any interference received, including interference that may cause undesired
operation.
Wahoo Fitness
90 West Wieuca Road, Suite 110
Atlanta, GA 30342
www.wahoofitness.com
1‐877‐978‐1112
Version 0.1
13
Advertisement
Table of Contents
