Table of Contents
Advertisement
8.
unwind approximately 15" of filter paper and
fold approximately 6" over one of the con-
veyor ribs so when you push the manual feed
button (figure 26), the conveyor will draw
the paper through the machine and into the
recovery cabinet.
note: For assistance, you can use a couple
pieces of tape to hold the filter paper on the
conveyor.
figure 26. Supply cabinet manual feed button.
9.
remove the five phillips head screws and
the recovery cabinet shroud (figure 27).
Shroud
figure 27. recovery cabinet shroud.
10. Connect the machine to power, and push and
hold the manual feed button while watching
the progress of the filter paper as it passes
through the machine.
11. When the filter paper just begins to enter at
the top of the recovery cabinet, release the
manual feed button and walk over to the
recovery cabinet.
g0649 Welding downdraft table
12. remove the end of the filter paper from the
conveyor, and then carefully pull the filter
paper so approximately 15" of paper extends
from the machine.
13. place the end of the filter paper in the slot cut
into the axle, and with your fingers, turn the
axle toward you so you get a couple of wraps
of paper on the roll (figure 28).
figure 28. Wrapping the recovery axle.
Make sure that the roll is wrapped in the
direction where, when installed, the filter
paper blocks the view of the roll, as seen
through the window shown in figure 23.
14. position the recovery axle onto the spring-
loaded spindle cone so that the slot in the
axle engages with the drive tang on the
spindle cone (figure 29).
tang
figure 29. Slot and drive tang alignment.
15. push the recovery cabinet manual feed but-
ton to draw up any slack in the filter paper
between the two rolls.
16. reinstall the recovery cabinet shroud.
Slot
-25-
Advertisement
Table of Contents
