Indicators - BenQ W1210ST User Manual

16. Connect the power and restart the projector.
17. After the startup logo is displayed, reset the lamp timer via the OSD menu.
• Under the Advanced OSD menu, go to System Setup : Advanced > Lamp Settings > Reset
Lamp Timer, and select Reset.
• Under the Basic OSD menu, if there's no signal connected to the projector, go to Reset Lamp
Timer and select Reset; if there are signals connected, go to Settings > Reset Lamp Timer,
and select Reset.
Do not reset if the lamp is not new or replaced as this could cause damage.
A "Reset Successfully" message is displayed to notify that the lamp time has been reset to "0".

Indicators

There are three indicators which show the status of the projector. Check the following information
about the indicator lights. If there is anything wrong, turn the projector off and contact your dealer.
Light
Orange Off
Green
Off
Flashing
Green Off
Orange
Off
Flashing
Red Red
Flashing Flashing
Green Off
Red Off
Green Off
Green Green
Off Off
Off Off
Red Red
Red
Red
Flashing
Red Green
Green
Red
Flashing
Power events
Stand-by mode
Off
Powering up
Off
Normal operation
Off
Normal power-down cooling
Off
Red
Downloading
Flashing
CW start fail
Red
Scaler reset fail
Red
Burn-in ON
Off
Burn-in OFF
Green
Lamp events
Lamp1 error in normal operation
Red
Red
Lamp is not lit up
Flashing
Thermal events
Fan 1 error (the actual fan speed is ±25% outside the desired
Off
speed)
Fan 2 error (the actual fan speed is ±25% outside the desired
Off
speed)
Fan 3 error (the actual fan speed is ±25% outside the desired
Off
speed)
Fan 4 error (the actual fan speed is ±25% outside the desired
Off
speed)
Status & Description
Maintenance 49