Table of Contents
Advertisement
20 INSTALLATION
Connecting Water Supply
1
Before connecting, turn off the water supply.
2
Slide the flexible stainless-steel water line or
copper tube into the elbow.
3
Tighten the compression nut and make sure that
the line is not kinked or pinched.
Valve
NOTE
• During the final installation check of the dishwasher,
an IE error code may appear on the display. Make
sure the water line is not kinked and the water
supply for the dishwasher has been turned on
before calling for service.
Connecting Power
NOTE
• The best location for the electrical conduit is on the
right side of the back wall. Re-route the power cable
before installation if the electrical conduit pipe is
longer than 3" (76 mm) and is centered on the back
wall.
1
Water supply
line
2
3
1
4
5
• Verify that the black wire is hot (120 V). If not,
or if you are unsure of the power supply, have it
checked by a licensed electrician.
• Do not leave stripped wire exposed. Trim
stripped wire to fit completely inside wire nuts.
Before beginning, turn off electrical power to the
unit at the circuit breaker.
Remove the junction box cover and then install
the strain relief.
1
2
Twist the wire nuts tightly onto the wires; then
wrap each connection with electrical tape.
2
Check again and make sure that all wires are
connected correctly: black to black, white to
white, green ground wire to green ground wire.
Replace the junction box cover.
WARNING
CAUTION
3
4
Advertisement
Table of Contents
