Application; Maintenance And Care - Sabo LB-934 Operator's Manual

10

APPLICATION

CHARGE BEFORE INITIAL USE
WARNING
Before assembling parts, adjusting settings, cleaning or when not in use, always remove the battery from the product first. Removing the battery prevents accidental switching-on, which
could cause serious injuries.
START/STOP THE BLOWER
See fig. 1 and 4
WARNING
Always wear safety goggles when using this device. In dusty areas, wear a face or dust mask.
WARNING
To avoid serious injuries or damage to the device, make sure that the blower tube is fitted before using the device.
·
Ensure that the battery is inserted into the leaf blower.
·
Push the release switch (1) to start the leaf blower.
·
Release the release switch (1) to stop.
NOTE
Wait until the motor has stopped after you have released the release switch (1) or have turned down the speed controller (3).
SPEED CONTROLLER
See Fig. 1 and 5
This leaf blower is fitted with a speed controller (3).
·
Press the release switch (1) to start the device.
· After starting the device, press the speed controller (3) down to increase the speed. You can then set the speed to the desired level.
·
To reduce the speed, turn the speed controller (3) up to reduce the speed to the desired level.
NOTE: If you lower the speed completely, the device is switched off and you have to repeat the first step.
TURBO BUTTON
See figure 1
·
Press the Turbo button (2). The machine is running at maximum speed.
·
Release the Turbo button (2). The machine is running at normal speed.
USING THE BLOWER
·
Blow around the outer edges of piles of brushed leaves to prevent them being spread again. Never blow directly into the middle of a pile.
·
To reduce the noise level, limit the number of appliances being used simultaneously.
·
Use brushes and rakes to loosen the leaves before blowing. In dusty conditions, moisten surfaces slightly if water is available.
·
Beware of children, animals, open windows or cars and blow leaves in a safe manner.
·
Clear up after using blowers or other devices. Properly dispose of the leaves.
11

MAINTENANCE AND CARE

WARNING
Remove the battery before adjusting, inspecting or cleaning the leaf blower in order to prevent injuries and the risk of fire and electric shock.
BATTERY
·
Store the battery charged.
·
After the charger's LED turns green, remove the battery from the charger and disconnect the charger from the power supply.
·
Charge the battery every time you observe that it is losing power. Never fully discharge the battery.
·
After charging, the battery can be stored in the charger as long as the charge is not connected to the mains.
WARNING
Only use original spare parts when replacing parts. The use of other parts can lead to danger or damage your device.
Do not use solvents to clean the plastic parts. Most plastics can be damaged by solvents available from retailers. Use a clean cloth to remove dirt, dust, oil, grease, etc.
25