Frigidaire FFSS2614QP Use & Care Manual page 26

CARE & CLEANING
Part
Interior & Door
Liners
Door Gaskets
Drawers & Bins
Glass Shelves
Toe Grille
Exterior &
Handles
Exterior &
Handles
(Stainless Steel
Models Only)
Replacing Light
Bulbs
26
Care & Cleaning Tips
What To Use
• Soap and water
• Baking soda and water
• Soap and water
• Soap and water
• Soap and water
• Glass cleaner
• Mild liquid sprays
• Soap and water
• Mild liquid sprays
• Vacuum attachment
• Soap and water
• Non Abrasive Glass Cleaner
• Soap and water
• Stainless Steel Cleaners
• Unplug refrigerator
• Wear gloves
• Remove light cover
• Replace old bulb
• Replace light cover
• Plug in the refrigerator
Tips and Precautions
Use two tablespoons of baking soda in
one quart of warm water. Be sure to
wring excess water out of sponge
or cloth before cleaning around
controls, light bulb or any electri-
cal part.
Wipe gaskets with a clean soft cloth.
Use a soft cloth to clean drawer run-
ners and tracks.
Allow glass to warm to room tempera-
ture before immersing in warm water.
Vacuum dust from front of toe grille.
Remove toe grille (see Installation
Instructions). Vacuum backside, wipe
with sudsy cloth or sponge. Rinse and
dry.
Do not use commercial household
cleaners containing ammonia, bleach
or alcohol to clean handles. Use a
soft cloth to clean smooth handles.
DO NOT use a dry cloth to clean
smooth doors.
Never use CHLORIDE or cleaners
with bleach to clean stainless steel.
Clean stainless steel front and handles
with non-abrasive soapy water and a
dishcloth. Rinse with clean water and a
soft cloth. Use a non-abrasive stainless
steel cleaner. These cleaners can be
purchased at most home improvement
or major department stores. Always
follow manufacturer's instructions. Do
not use household cleaners containing
ammonia or bleach.
NOTE: Always clean, wipe and dry
with the grain to prevent scratch-
ing. Wash the rest of the cabinet with
warm water and mild liquid detergent.
Rinse well, and wipe dry with a clean
soft cloth.
CAUTION: Wear gloves when
replacing light bulbs to avoid get-
ting cut.
Use same wattage when replacing
bulb.