Table of Contents
Advertisement
Fault
flashes.
flashes.
lights up.
flashes.
All other error codes.
The appliance is not
working.
Cause and troubleshooting
The water pressure is low.
No remedial action possible.
The filters in the water inflow are blocked.
Clean the filters in the water inflow → Page 48.
▶
The tap is turned off.
Turn on the tap.
▶
The water inlet hose is kinked or jammed.
Ensure that the water inlet hose is not kinked or
▶
jammed.
The automatic voltage control system detects an un-
authorised voltage under-usage.
No remedial action possible.
▶
Note: If the power supply is stable, the programme
continues to run as normal.
Voltage under-usage may cause extension of a pro-
gramme.
No remedial action possible.
Voltage under-usage may cause extension of a pro-
gramme.
No remedial action possible.
The temperature is too high.
Wait until the temperature has dropped.
▶
→ "Cancelling the programme", Page 40
▶
Water level is too high.
Start the Drain programme.
▶
Laundry is caught in the door.
Open the door again.
1.
Remove any trapped laundry.
2.
Close the door.
3.
Press
to start the programme.
4.
Door is not closed.
Close the door.
1.
Press
to start the programme.
2.
Malfunction
Call the after-sales service.
▶
→ "Customer Service", Page 60
The mains plug of the power cord is not plugged in.
Connect the appliance to the power supply.
▶
The circuit breaker is faulty.
Troubleshooting en
51
Advertisement
Table of Contents
