Engine Adjustment; Start-Up The Engine - Mile HaoXianG Model Technology DLE30 User Manual

三、发动机的调整(ENGINE ADJUSTMENT)
1、每台发动机出厂时都经过了初步调整，用户可以直接使用。但各地区的海拔高度
将会影响化油器的正常工作，化油器油针可能需要进行微调才能达到最佳的工作位置。
Every engine has been adjusted to average mixture settings which will most likely allow
the engine to start and run in most locations. However, as altitudes and barometric
pressures vary by location, it is very likely that the carburetor mixture settings will need
to be adjusted to obtain optimum performance.
2、功能及调整（Functions and Adjustments）
（1） 、风门，冷启动时使用(Choke Lever)
（2） 、油门(Throttle Lever)
（3） 、怠速调节螺丝(Idle Speed Adjustment Screw)
（4） 、低速油针(Low Speed Mixture Adjustment Screw)
（5） 、高速油针(High Speed Mixture Adjustment Screw)
调整：顺时针转动怠速螺丝3将增大怠速转速，同时要配合低速油针4一起调整，顺
时针转动低速油针减少油量 （一般是把油针拧到底再退回1.5圈） ； 高速油针5(退回1.5-2圈)
最好使用转速表来调整，使发动机达到最高转速，加减速顺畅为最佳。
ADJUSTMENT: A general starting point is 1.5 turns out for the low speed needle (See
No. 4), and 1.5-2 turns out for the high speed needle (See No. 5).
Adjust the High needle to peak rpm. If ever the engine slows or dies while at full throttle,
the high speed mixture is likely too lean.
Adjust the Low needle until you achieve a smooth idle and a reliable transition to high
throttle. If the engine dies when the throttle is advanced, the mixture is likely too lean. If
the engine stumbles when the throttle is advanced, the mixture is likely too rich.
调整化油器高速油针时请注意：混合气调整过稀将导致发动机严重过热和火花塞烧
毁。燃烧后火花塞的颜色应该是黄色,说明混合气浓度比较合适.
Caution: Don't be tempted to run an overly rich mixture. A too rich mixture will
only result in poor engine performance, pre-mature carbon buildup, a fouled plug
and excessive exhaust residue. However, a lean mixture will also damage the
cylinder and piston badly. After few flights, check the spark plug, it appears to be
yellow if mixture had been set properly.
3、化油器可以翻转180度使用，翻转使用时请注意垫片的方向。
Carburetor can be rotated 180° for use, please be ware the
carburetor is rotated.
4、发动机的启动 (Start-up the engine)
（1）关闭风门，加大油门,打开点火电源.
direction
3
of gasket when the