Controlling Your Tv With The Supplied Remote - LG RC298 Owner's Manual

Controlling Your TV with the Supplied Remote

You can control the sound level, input source, and
power switch of your LG TV with the supplied remote.
You can control your TV using the buttons below.
By pressing You can
POWER Turn the TV on or off.
AV/INPUT Switch the TV's input source
between the TV and other input
sources.
PR/CH +/– Scans up or down through
memorized channels.
VOL +/– Adjust the volume of the TV.
Recording the NTSC format
signals
You can record NTSC format signals from the analog
or the DV inputs.
1. Load a recordable DVD discs formatted in NTSC.
(Refer to "How to create an NTSC formatted DVD
disc" on right.)
2. Press AV/INPUT repeatedly to select an external
NTSC input (AV1, AV2, or DV).
3. Press REC (z) once.
4. Press STOP (x) to stop recording.
TV Control
Buttons
Controlling other TVs with the remote
You can control the sound level, input source, and
power switch of non-LG TVs as well. If your TV is listed
in the table below, set the appropriate manufacturer
code.
1. While holding down TV POWER button, press the
number buttons to select the manufacturer code
for your TV (see the table below).
2. Release TV POWER button.
Code numbers of controllable TVs
If more than one code number is listed, try entering one
of them at a time until you find the one that works with
your TV.
Manufacturer Code Number
LG / GoldStar 1 (Default), 2
Zenith 1, 3, 4
Samsung 6, 7
Sony 8, 9
Hitachi 4
otes
Depending on your TV, some or all buttons may not
function on the TV, even after entering the correct
manufacturer code.
If you enter a new code number, the code number
previously entered will be erased.
When you replace the batteries of the remote, the
code number you have set may be reset to the default
setting. Set the appropriate code number again.
How to create an NTSC formatted DVD
disc
1. Press AV/INPUT repeatedly to select an external
NTSC input (AV1, AV2, or DV).
2. Load a recordable DVD discs.
3. Initialize the disc on the setup menu.
(Refer to "Initialize" on page 19.)
Note:
You cannot play back a DivX file while viewing an
NTSC format signals from the analog or the DV inputs.
To play back the DivX file, you must select tuner mode.
55