RIDGID A JOBMAX R8223400 Operator's Manual page 10

OPERATION
NOTE: The tool will not run unless the direction of rotation
selector is pushed fully to the left or right.
Avoid running the tool at low speeds for extended periods
of time. Running at low speeds under constant usage may
cause the tool to become overheated. If this occurs, cool the
tool by running it without a load and at full speed.
CHANGING HEADS
See Figure 4, page 13.
 Remove the battery pack from the power handle.
 Depress the latches on both sides of the power handle
with one hand while pulling the head away from the tool
with your other hand.
 Place the desired head on the power handle and push
until the latches click into position. Pull on the head to
make sure it is securely installed before proceeding.
NOTE: The head can be installed at 90° angles to best
suit your application needs.
10 - English