Advertisement
Location
1.
The antenna receives and transmits within a horizontal angle of 30°.
Locate the antenna so linked equipment will be in this beam. The
center of the antenna beam is the long axis of the antenna, with the
beam pointing away from the mast.
2.
Surrounding objects such as metal structures, trees, power lines,
other antennas, etc. will reduce antenna efficiency and may block
signals. Choose a location that is high and clear of obstruction.
3.
Make absolutely sure that the location is safe, especially from
possible contact with power lines. See warning on back.
Beam Direction
(2) Open Drain Holes
on bottom
Horizontal Polarized Mounting
1.
To mount the antenna in the horizontal
polarized position, rotate antenna into
the position shown in Figure B. The
cable should be exiting from the side of
the antenna and the plugged drain
holes facing down.
2.
Remove (2) drain hole plugs from
bottom and insert into side holes.
3.
Attach antenna to L-Bracket using the
(4) pan head screws.
IP-00009 Rev. A – 10/07 Page 1/2
INSTALLATION INSTRUCTIONS: HG2415Y
30°
(2) Drain Hole Plugs
Side exiting cable
Figure B
Horizontal Polarized Position
L-com Global Connectivity | 50 High St., West Mill, 3rd floor, Suite #30 | North Andover, MA 01845 | USA
© L-com, Inc. All Rights Reserved. L-com Global Connectivity and the L-com Logo are registered marks.
Toll Free Ordering and Technical Support: 1-800-343-1455
Figure A
Vertical Polarized Position
(As shipped from factory)
(4) Pan Head Screws
Mounting
1.
The antenna can be vertical polarized mounted (Figure A) or
horizontal polarized mounted (Figure B). It is shipped from the
factory in the vertical polarized position.
2.
Mount the antenna as shown, ensuring U-Bolt nuts are securely
tightened to prevent antenna shift in high wind.
3.
The antenna can be mounted in a up or down tilt position from 0-60°.
See below for mounting options.
10°
Fixed
20°
Mounting
30°
L-Bracket
40°
50°
60°
L-Bracket shown for down-tilt mounting. For up-tilt,
rotate bracket 180 degrees when attaching to antenna.
Copyright © This drawing is property of L-com Global Connectivity. All rights reserved.
www.L-com.com
(2) Drain Hole Plugs
(2) Open Drain Holes
on bottom
Bottom exiting cable
L-Bracket Mounting Options
0°
Variable
Mounting
0°-60°
Fixed 0° Mounting
Advertisement
