Install System Memory - Biostar B365GTA Manual

2.4 Install System Memory

DDR4 Modules
Step 1: Unlock a DIMM slot by pressing the
retaining clips outward. Align a DIMM on the
slot such that the notch on the DIMM matches
the break on the slot.
Note
» If the DIMM does not go in smoothly, do not force it. Pull it all the way out and try again.
Memory Capacity
DIMM Socket Location
DIMMA1
DIMMA2
DIMMB1
DIMMB2
Dual Channel Memory Installation
Please refer to the following requirements to activate Dual Channel function:
Install memory module of the same density in pairs, shown in the table.
Dual Channel Status
Enabled
Enabled
Enabled
(O means memory installed, X means memory not installed.)
Note
» When installing more than one memory module, we recommend to use the same brand and
capacity memory on this motherboard.
DDR4 Module Total Memory Size
4GB/8GB/16GB
4GB/8GB/16GB
Max is 64GB.
4GB/8GB/16GB
4GB/8GB/16GB
DIMMA1 DIMMA2
O X
X O
O O
Step 2: Insert the DIMM vertically and
firmly into the slot until the retaining clips
snap back in place and the DIMM is properly
seated.
DIMMB1 DIMMB2
O X
X O
O O
Chapter 2: Hardware installation | 11
B365GTA