Zenith A20A22DOM Operating Manual And Warranty page 6

P A G E 6 I N S TA L L AT I O N
Hook Up Antenna and VCR to your TV
Connect your
off-air
antenna and
VCR to your
1
Entertainment
Machine.
2
3
4
5
S TA N DA R D
Locate the Antenna/Cable jack on
the back of your Entertainment
Machine.
Connect the cable that runs from
the wall directly to this jack,
according to the diagram to the
right.
Remove the back of the remote
and put in two AAA batteries.
back of
remote
Plug in your TV. Do not plug it
into a switched outlet. Your
Entertainment Machine is designed
to operate on household current,
120-volt 60 Hertz AC. Do not
attempt to operate it on DC
Current.
Go to page 8 to Auto Program your
Entertainment Machine.
Remember, when screwing
RF cables onto jacks, clockwise
tightens, and counterclockwise
loosens.
No A/V cables are included with
your Zenith Entertainment
Machine.
Without A/V cables, most VCRs will
not play videocassettes in stereo
sound.
Flat wire Antenna to TV with VCR
Antenna
Flat wire
(300 ohm)
300/75 ohm
Adapter
TV back
RF coaxial wire
TV back panel
(expanded view)
A/V cables
Audio In Video
not included
Antenna
with TV
Cable
Coaxial wire Antenna to TV with VCR
Antenna
RF coaxial cable
(75 ohm)
TV back
RF coaxial wire
(75 ohm)
not included
TV back panel
(expanded view)
Audio In Video
Antenna
Cable
VCR back
VCR back AV panel
output
In
switch
3 4
Out
Video
Audio
(75 ohm)
not included
with TV
VCR back
VCR back AV panel
output
In
switch
3 4
Out Video
Audio
with TV
A/V cables
not included
with TV
206-3371-A