Do you have a question about the Laser Level and is the answer not in the manual?
Questions and answers
Summary of Contents for Chauvet Laser Level
Page 1
LASER LIGHT AVOID DIRECT EYE EXPOSURE CLASS 3R LASER PRODUCT CLASSIFIED PER EN/IEC 60825-1:2007 Complies with FDA performance standards for laser products except for deviations pursuant to Laser Notice No. 50, dated User Manual June 24, 2007 ...
CHAUVET®, upon receipt of the damaged merchandise. Failure to do so in a timely manner may invalidate your claim with the carrier. In addition, retain the container and all the packing material for inspection.
Safety Instructions Please read the following notes carefully because they include important safety information about the installation, usage, and maintenance of this product. Keep this User Manual for future consultation. If you sell this product to another user, be sure that they also receive this document. ...
Non Interlocked Housing Warning This unit contains high power laser devices internally. Do not open the laser housing, due to potential exposure to unsafe levels of laser radiation. The laser power levels, accessible if the unit is opened, can cause instant blindness, skin burns, and fires.
LASER EXPOSURE WARNING Laser light - Avoid direct eye contact! Further guidelines and safety programs for safe use of lasers can be found in the ANSI Z136.1 Standard “For Safe Use of Lasers”, available from the Laser Institute of America: www.laserinstitute.org. Many local governments, corporations, agencies, military and others, require all lasers to be used under the guidelines of ANSI Z136.1.
2. I NTRODUCTION Product Overview Laser Output Green Laser Dimmer 12 V Power In MinLaser User Manual Mode Button LED Indicator Microphone Wireless Remote Receiver Cooling Fan August 2011...
This fixture includes an external power supply which is auto-ranging and runs on 100~240 VAC, 50/60 Hz power. Only use the included power supply! To obtain a replacement power supply, contact Chauvet®. To determine the power requirements for a particular fixture, see the label affixed to the Power Supply back plate of the fixture or refer to the fixture’s specifications chart.
Page 10
Adjustable Stand Angle Adjustment Knob A Angle Adjustment Knob B Floor Stand, Flexible Feet (3) MinLaser User Manual August 2011...
Proper Usage This product is for overhead mounting only. For safety purposes, CHAUVET® recommends mounting your lighting effect products on steady elevated platforms or sturdy overhead supports using suitable hanging clamps. In all cases, you must use safety cables. You can obtain appropriate mounting hardware from your lighting vendor.
4. O PERATING NSTRUCTIONS Manual Mode Access the five different operating modes available in this fixture by using the <MODE> button on the front panel. Press <MODE> to cycle through the modes. Please see a description of each mode below. Mode The LED indicator on the front of the fixture will be green when a sound-active mode is selected.
Device does not power up Fixture is not responding to Loss of signal If you still have a problem after trying the above solutions, please contact CHAUVET® Technical Support. MinLaser User Manual OSSIBLE AUSE Check total load placed on the ...
General Maintenance To maintain optimum performance and minimize wear, fixtures should be cleaned frequently. Usage and environment are contributing factors in determining frequency. As a general rule, fixtures should be cleaned at least twice a month. Dust build up reduces light output performance and can cause overheating.
As a suggestion, proper UPS packing or double-boxing is always a safe method to use. CHAUVET® reserves the right to use its own discretion to repair or replace product(s).
WARRANTY INFORMATION Warranty (fixture, excluding the laser diodes) ... 1-year limited warranty Warranty (laser diodes) ... 90-day limited warranty ONTACT WORLD WIDE General Information ... CHAUVET® Technical Support ... CHAUVET® World Wide Web ... MinLaser User Manual toll free: 800.762.1084 voice: 954.929.1115 (Press 4)
Need help?
Do you have a question about the Laser Level and is the answer not in the manual?
Questions and answers