LG WT7710H A Series Owner's Manual page 47

ERROR CODES (continued)
Problem
The display shows:
Water in the washer drains slowly
or not at all, or the display shows:
The display shows:
The display shows:
The display shows:
The display shows :
The display shows:
The display shows:
The display shows:
Possible Cause
Foreign objects, such as coins,
pins, clips, etc., caught between
the wash plate and the inner
basket.
Drain hose is kinked, pinched, or
clogged
Drain discharge is more than 96
inches above bottom of washer.
The washer has detected an out of
balance load.
If the UE rebalancing operation
(see above) is not successful, this
error will be displayed.
The load is too small.
Heavy articles are mixed with
lighter items.
The load is out of balance.
Control error.
Water level is too high due to a
faulty water valve.
The water level sensor is not
working correctly.
A motor error has occurred.
Clutch error.
TROUBLESHOOTING
Solutions
Turn off the washer and then press the Power
button. Press the spin speed button without
selecting a cycle to drain and spin the load.
When the spin is complete, remove the
clothes and then find and remove any objects
caught in the wash plate.
Always check pockets, etc., before wash-
ing to prevent error codes or damage to the
washer or clothing.
Make sure the drain hose is free of clogs,
kinks, etc., and is not pinched behind or
under the washer.
Adjust or repair drain. Maximum drain height
is 96 inches (8 ft.)
If the washer detects a load that is too far
out of balance to spin, it will display this code
while it is attempting to rebalance the load. The
washer will add water and try to redistribute
the load automatically. As a result, the cycle
will take longer than initially estimated. This
display is for your information only, and no
action is required.
The automatic attempt to rebalance the load
was not successful. The cycle has been
paused to allow the load to be manually
adjusted.
Small loads may need additional items to be
added to allow the washer to balance the
loads.
The load may have heavy items loaded with
lighter items. Always try to wash articles of
somewhat similar weight to allow the washer
to evenly distribute the weight of the load for
spinning.
Manually redistribute the load if articles have
become tangled preventing the automatic
distribution from working properly.
Unplug the washer and wait 60 seconds.
Reconnect power and try again. If the error
reappears, call for service.
Close the water faucets, unplug the washer,
and call for service.
Close the water faucets, unplug the washer,
and call for service.
Allow the washer to stand for 30 minutes
and then restart the cycle. If the LE error
code persists, call for service.
Mechanical failure.
Unplug the washer and call for service.
47