Comfort 60-2907P08 Operating Manual

OPERATING MANUAL
10 MOTOR MASSAGE MAT WITH HEAT
Please read all instructions before using model 60-2907P08.
Contents

Model 60-2907P08 Massaging Mat with home adapter

Getting started

1. Pull the non-elastic strap around mat back and fasten it to its supporter.
2. To use massage mat at home, connect the AC adapter output
(voltage: +12V 1A) male-plug with the female-plug on the back
of the mat. Then plug the AC adapter into a wall socket (voltage: 120V/60Hz).
AC Adaptor
3. Lie comfortably on the mat and use the hand controller to select the desired functions.
Caution: Be careful not to damage the mat with plastic fasteners during installation.

Heat

Press the "HEAT" button to turn the heat function on or off. A built-in thermostat is to
control the temperature within a safe range.
Note: This product uses a warming heat as shown. It is not intended to be used as a
therapeutic heating pad. Please allow a few minutes to reach maximum temperature.
Mat reaches maximum temperature of 140F after approx. 7 minutes.

Built-in Timer

The cushion has a built-in timer that deactivates the cushion after 15 minutes.
After 15 minutes of use please wait 15 minutes and simply turn cushion on again.
Connector Position
Body zone
indicator lights
Intensity indicator lights
(LO, MED, HI)
On / Off
Intensity selector
Heat
CONTROLLER
Push for Neck/
Upper back massage
Push for Mid-back
Massage
Push for Lower Back/
Lumbar massgae
Push for Leg / Thigh
massage
Mode indicator lights
(M1 - M5)
Push to turn heat
on / off
Mode selector -
choose from 5
pre-programmed
massage
modes
CUSHION
Massage
areas