Zanussi ZNTN19ES1 User Manual page 18

Problem
Water flows inside the refriger-
ator.
Water flows on the floor.
Temperature cannot be set.
The temperature in the appli-
ance is too low/too high.
DEMO appears on the display.
A or or symbol is
shown instead of numbers on
the temperature display.
18
Possible cause
Food products prevent the wa-
ter from flowing into the water
collector.
The water outlet is clogged.
The melting water outlet is not
connected to the evaporative
tray above the compressor.
The "FastFreeze function" or
"FastCool function" is switched
on.
The temperature is not set cor-
rectly.
The door is not closed correct-
ly.
The food products' tempera-
ture is too high.
Many food products are stored
at the same time.
The door has been opened of-
ten.
The FastFreeze function is
switched on.
The FastCool function is
switched on.
There is no cold air circulation
in the appliance.
The appliance is in demonstra-
tion mode.
Temperature sensor problem.
Solution
Make sure that food products
do not touch the rear plate.
Clean the water outlet.
Attach the melting water outlet
to the evaporative tray.
Switch off "FastFreeze func-
tion" or "FastCool function"
manually, or wait until the func-
tion deactivates automatically
to set the temperature. Refer
to "FastFreeze function" or
"FastCool function" section.
Set a higher/lower tempera-
ture.
Refer to "Closing the door"
section.
Let the food products temper-
ature decrease to room tem-
perature before storage.
Store less food products at the
same time.
Open the door only if necessa-
ry.
Refer to "FastFreeze function"
section.
Refer to "FastCool function"
section.
Make sure that there is cold air
circulation in the appliance.
Refer to "Hints and Tips" chap-
ter.
Keep the OK key pressed for
approximately 10 seconds until
a long sound is heard and the
display turns off for a short
time.
Contact the nearest Author-
ized Service Centre (the cool-
ing system will continue to
keep food products cold, but
temperature adjustment will
not be possible).