Kyocera S2150 Get Started page 17

to a base station antenna, phone design and other
factors. What is important to remember is that each
phone meets strict federal guidelines. Variations in
SARs do not represent a variation in safety.
All phones must meet the federal standard, which
incorporates a substantial margin of safety. As stated
above, variations in SAR values between different
model phones do not mean variations in safety. SAR
values at or below the federal standard of 1.6 W/kg
are considered safe for use by the public.
The highest reported SAR values of the Kona are:
Cellular CDMA mode (Part 22):
Head: 0.59 W/kg; Body-worn: 1.26 W/kg
PCS mode (Part 24):
Head: 0.18 W/kg; Body-worn: 0.68 W/kg
AWS mode (Part 27):
Head: 0.61 W/kg; Body-worn: 1.05 W/kg
FCC Radio Frequency Emission
This phone meets the FCC Radio Frequency Emission
Guidelines.
FCC ID number: V65S2150.
More information on the phone's SAR can be found
from the following FCC website:
http://www.fcc.gov/oet/ea/.
FCC Notice
This device complies with Part 15 of the FCC Rules.
Operation is subject to the following two conditions:
(1) this device may not cause harmful interference,
and (2) this device must accept any interference
received, including interference that may cause
undesired operation.
Changes or modifications not expressly approved by
the party responsible for compliance could void the
user's authority to operate the equipment.
Note: This equipment has been tested and found to
comply with the limits for a Class B digital
device, pursuant to Part 15 of the FCC Rules.
These limits are designed to provide reasonable
protection against harmful interference in a
residential installation. This equipment generates,
uses and can radiate radio frequency energy and, if
not installed and used in accordance with the
instructions, may cause harmful interference to radio
communications.
However, there is no guarantee that interference will
not occur in a particular installation.
If this equipment does cause harmful interference to
radio or television reception, which can be
determined by turning the equipment off and on, the
user is encouraged to try to correct the interference
by one or more of the following measures:
Important Safety Information 17