Lenovo D27-30 User Manual page 9

1-4 D27-30 Flat Panel Monitor User's Guide
3. Connect the analog signal cable to the D-SUB connector of the monitor and the other end on
the back of the computer.
4.
Plug the monitor power cord and the computer cord into grounded electrical outlets.
Note: A certified power supply cord has to be used with this equipment. The relevant national
installation and/or equipment regulations shall be considered. A certified power supply
cord not lighter than ordinary polyvinyl chloride flexible cord according to IEC 60227
(designation H05VV-F 3G 0.75mm² or H05VVH2-F2 3G 0.75mm²) shall be used.
Alternative a flexible cord be of synthetic rubber according to IEC 60245 (designation
H05RR-F 3G 0.75mm²) shall be used.