JVC CA-MXKA6 Service Manual page 9

Removing the front panel assembly
Prior to performing the following procedures, remove
the top cover.
Also remove the CD changer unit.
1. Disconnect the parallel wire and the cord wire from
the connectors CN701, CN101 on the power amp.
PCB.
2. Remove one screws H retaining the front panel
assembly onto the bottom of the body.
3. Remove two screws I on the left and right side of the set
retaining the panel front from the bottom and then
remove then GND lug b that comes from the power
amp and supply PCB.
4. Disengage the claws c on both sides of the front
panel assembly and then remove the assembly.
(See Fig.10 to 11)
H
Fig.10
Pow er amp and
supply PCB
GND lug b
Claw c
Fig.11
MX-KA6
I
1-9