Gigabyte GA-8I865GM-775 User Manual page 36

POWER ON Function
Disabled
Any KEY
Mouse
Mouse/Any KEY
Onboard Serial Port 1
Auto
3F8/IRQ4
2F8/IRQ3
3E8/IRQ4
2E8/IRQ3
Disabled
Onboard Serial Port 2
Auto
3F8/IRQ4
2F8/IRQ3
3E8/IRQ4
2E8/IRQ3
Disabled
UART Mode Select
This item allows you to determine which Infra Red(IR) function of Onboard I/O chip.
Normal
IrDA
ASKIR
UR2 Duplex Mode
This feature allows you to seclect IR mode.
This function will available when "UART Mode Select" doesn't set at Normal.
Half
Full
Onboard Parallel port
Disabled
378/IRQ7
278/IRQ5
3BC/IRQ7
Parallel Port Mode
SPP
EPP1.9+SPP
ECP
EPP1.9+ECP
PRINTER
EPP1.7+SPP
EPP1.7+ECP
ECP Mode Use DMA
3
1
GA-8I865GM(F)-775 Motherboard
Disable this function. (Default value)
Press any key to power on the system.
Double click on mouse left button to power on the system.
Press any key or double click on mouse left button to power on the system.
BIOS will automatically setup the port 1 address.
Enable onboard Serial port 1 and address is 3F8. (Default value)
Enable onboard Serial port 1 and address is 2F8.
Enable onboard Serial port 1 and address is 3E8.
Enable onboard Serial port 1 and address is 2E8.
Disable onboard Serial port 1.
BIOS will automatically setup the port 1 address.
Enable onboard Serial port 2 and address is 3F8.
Enable onboard Serial port 2 and address is 2F8. (Default value)
Enable onboard Serial port 2 and address is 3E8.
Enable onboard Serial port 2 and address is 2E8.
Disable onboard Serial port 2.
Set onboard I/O chip UART to normal mode. (Default value)
Set onboard I/O chip UART to IrDA mode.
Set onboard I/O chip UART to ASKIR mode.
IR Function Duplex Half. (Default value)
IR Function Duplex Full.
Disable onboard LPT port.
Enable onboard LPT port and address is 378/IRQ7. (Default value)
Enable onboard LPT port and address is 278/IRQ5.
Enable onboard LPT port and address is 3BC/IRQ7.
Using Parallel port as Standard Parallel Port.
Using Parallel port as Enhanced Parallel Port 1.9 and SPP mode.
Using Parallel port as Extended Capabilities Port.
Using Parallel port as Enhanced Parallel Port 1.9 and ECP mode.
Using Parallel port as printer port. (Default value)
Using Parallel port as Enhanced Parallel Port 1.7 and SPP mode.
Using Parallel port as Enhanced Parallel Port 1.7 and ECP mode.
Set ECP Mode Use DMA to 3. (Default value)
Set ECP Mode Use DMA to 1.
- 36 -