Table of Contents
Advertisement
9 ) F_PANEL (2x10 pins connector)
HD (IDE Hard Disk Active LED)
(Blue)
SPK (Speaker Connector)
(Amber)
RES (Reset Switch)
(Green)
PW (Soft Power Connector)
(Red)
MSG(Message LED/Power/
Sleep LED)(Yellow)
NC( Purple)
Ø Please connect the power LED, PC speaker, reset switch and power switch etc of your chassis
front panel to the F_PANEL connector according to the pin assignment above.
10) F_AUDIO (Front Audio Connector)
10
Rear Audio (L)
Rear Audio (R)
POWER
GND
2
11) SUR_CEN
BASS_OUT
SUR OUTR
1
1
1
2
1
1
1
Pin 1: LED anode(+)
Pin 2: LED cathode(-)
Pin 1: VCC(+)
Pin 2- Pin 3: NC
Pin 4: Data(-)
Open: Normal Operation
Close: Reset Hardware System
Open: Normal Operation
Close: Power On/Off
Pin 1: LED anode(+)
Pin 2: LED cathode(-)
N C
9
Front Audio (L)
Reserved
Front Audio (R)
REF
MIC
1
CENTER_OUT
GND
SUR OUTL
- 19 -
1
20
19
Ø If you want to use "Front Audio" connector,
you must remove 5-6, 9-10 Jumper. In order to
utilize the front audio header, yourchassis must
have front audio connector. Also please make
sure the pin assigment on the cable is the same
as the pin assigment on the MB header. To find
out if the chassis you are buying support front
audio connector, please contact your dealer.
Ø Please contact your nearest dealer for optional
SUR_CEN cable.
Hardware Installation Process
Advertisement
Table of Contents
