Table of Contents
Advertisement
STEP 6: Load BIOS defaults.
Normally the system redetects all devices after BIOS has been upgraded. Therefore, we highly
recommend reloading the BIOS defaults after BIOS has been upgraded. This important step resets
everything after the flash.
(1) Take out the floppy diskette from floppy drive, and then restart the system. The boot up screen will
indicate your motherboard model and current BIOS version.
Ame r ican
Meg a tre n d s AMIBIOS ( C) 19 9 9 Ame ri ca n Me ga tr en d
7 VTX F4
Ch eck Syste m Hea lth OK
AMD- Ath lo n( tm) Pr oce ssor -90 0MHz
Ch ecki ng N VR AM...
2621 44KB
W ai t...
Pr ess F1 to en ter D ual BIOS Util ity. Pre ss ESC to qu it
Pr ess any key to co ntiu ne
( C ) Amer ica n Meg atr end s Inc.,
63-0001- 001199-00101111- 071595-VIA_K7-GA7VTX1-F
(2) Don't forget to press <DEL> key to enter BIOS setup again when system is boot up. Use the arrows
to highlight the item "LOAD SETUP DEFAULTS" then press "Enter". System will ask "Load Setup
Defaults (Y/N)?" Press "Y" and "Enter" keys to confirm.
AMIBIOS SIM PLE SETUP UTILITY - VERSION 1.24b
(C) 2001 American Megatrends, Inc. All Rights Reserved
STANDARD CMOS SETUP
BIOS FEATURES SETUP
CHIPSET FEATURES SETUP
POWER MANAGEMENT SETUP
PNP / PCI CONFIGURATION
LOAD BIOS DEFAULTS
LOAD SETUP DEFAULTS
ESC: Quit
hifg
F6: Load BIOS Defaults
R e le a se :0 9 /1 6 /9 9
INTEGRATED PERIPHERALS
HARDWARE MONITOR & M ISC SETUP
SUPERVISOR PASSWORD
USER PASSWORD
Load Setup Defaults? (Y/N)?N
IDE HDD AUTO DETECTION
SAVE & EXIT SETUP
EXIT WITHOUT SAVING
: Select Item
(Shift)F2 : Change Color
F7: Load Setup Defaults
Load Setup Defaults
- 63 -
F5: Old Values
F10:Save & Exit
Technical Reference
Advertisement
Table of Contents
